Quantcast
Jump to content


Tw400 neutral safety switch bypass

john s

By john s
in UTV General Discussion

 Share

Recommended Posts

kenfain Experienced

kenfain

Posted
Posted

Do you know where the actuator is? If you find that, it's a simple process to bypass. If it's actuated by being open, then you can just remove it, or pull the wire/wires. If it's a closed switch then you just connect the wires, to complete the circuit. 

Most of the switch bypass that I've done, have been pretty evenly divided between the two methods. In your situation, bypassing the neutral safety switch. I'd look for the switch somewhere around the shift linkage. 

Obviously it'd be better to fix the problem, than bypass the safety switch. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • William P
      Engine cooling, radiator boiling overr
      By William P
      After a short while of engine running the temp light comes on and the water in the radiator water is boiling., water level is ok pryer to starting engine. This is consistent. Coleman 400 bout 3yrs old
    • lmarkie
      Bulldog BD700 Engine Swap
      By lmarkie
      I swapped out the Subaru motor for a Predator 670cc. If I remove the heat shield around the muffler, The stock muffler sits in there just fine with 1" to spare.
      Only problem is the exhaust exit is toward the back seat instead of out the back.
      Do you all think that the stock exhaust would be okay (just as effective) if cut a hole and welded a pipe on the reversed (opposite) end? Of course, plug the old exit end. Other option I thought of was to roll a tube 180° with a 7" center line radius and finish extention of 12" or so.
      Any thoughts?
    • diamondjfarm
      Good mornin' all. Just joined.
      By diamondjfarm
      I got an old 2003 Arctic Cat 375 Auto, and just bought a 2008 AC 650 side by side. Got a new starter, solenoid, and battery for the 650. Gonna change the crankcase oil and filter while I'm at it.
      Anything I oughta watch out for from them that's done the starter/solenoid on this model?
      Don't have a manual yet for the 650. Any recommendations for oil weight/grade?
      Thanks.
    • Ronald
      Check engine light on Axis Pro 70
      By Ronald
      Check engine light comes on after engine runs continuously for 5 minutes or so.  I can shut down the engine and restart and check engine light goes out, then comes back on after running 5 minutes or so?  What ya think?
    • Brake & Suspension Clearance Event
    • sxr951
      wanted. 2015 or abouts engine/ air duct, cover console
      By sxr951
      wanted. 2015 or abouts engine/ air duct, cover console
      whatcha got! let me know thx!

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...