Quantcast
Jump to content

Joyner Renegade R4 - Coolant Thermometer Reads HOT


MJG

Recommended Posts

Hello, 

Coolant thermometer gets to max temperature after about 7-10 minutes idling, above the 237 degree marker.   However, the coolant temperature light does not turn on.  Radiator hose is cool, the hose to the block is hot, but not extremely hot.  The engine block doesn’t seem to be hot either.  The thermostat opens up and works. 
 

Does anyone know what the issue could be?  Faulty water pump maybe? 

Link to comment
Share on other sites

  • MJG changed the title to Joyner Renegade R4 - Coolant Thermometer Reads HOT

I ended up replacing the thermostat and flushing the radiator and coolant with new coolant.  It was quite dirty.  Seems to be working better, but still running a bit hot. I also bought a new water pump for it and going to end up changing that to see if that regulates temp much better. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Steve B
      My "R" light on the dash will not go out when I take the UTV out of reverse and put it into any other gear. Is this just the light switch issue or will this effect engine performance in the other gears?
    • By hdtran
      Hy (pronounce he), just bought a Hisun Sector E1.
      I'll be using it to haul logs and stuff in the Sangre de Cristo mountains.
    • By moonrover
      Mine is overheated/burned/melt at connection with its wire connector, parts are ordered to replace both them.  This seems to be a common issue, and some of you already replaced it. I right now just connect the wires, so the fan runs  all the time whenever the initiation is on, but it's better let fan runs as needed with a working temperature sensor/switch. 
      Question: Does some coolant come out by removing the switch/sensor from radiator?  Or, is the threaded hole all the way inside radiator?   If the answer is yes,  I want to drain or extract  some coolant to make its level below the sensor before replacing it, so I don't make a mess with coolant spilled out 
      Thank you.  
    • By Hugh
      My 2018 Hisun sector crew engine cut off after about 15 minutes run. There is no indicator of what is wrong, no error code just die and won't restart until it cool down. I notice that the fan is not running but the temp indicator is on low temp, no overheat indicator. I checked the radiator fluid, it is cool to touch.
      Cooling fans are working, I can hear it running once awhile if I can get the engine warm up enough.  Thank you for all the help.
       
      Hugh
    • By packersfan
      I have a hisun 500 got from a auction and when turning a corner left or right it's a two hand job then when you left go snaps back.any help on what to look at would be appreciated.
      Also blows blue smoke until she gets warm then it's ok 
×
×
  • Create New...