2018 Can-Am X3 DS Turbo R
-
Similar Topics
-
By Hugh
My 2018 Hisun sector crew engine cut off after about 15 minutes run. There is no indicator of what is wrong, no error code just die and won't restart until it cool down. I notice that the fan is not running but the temp indicator is on low temp, no overheat indicator. I checked the radiator fluid, it is cool to touch.
Cooling fans are working, I can hear it running once awhile if I can get the engine warm up enough. Thank you for all the help.
Hugh
-
By CBS
View File 2018 HISUN HS-550 Sector Rural King Manuals
This is the Service manual, Parts manual, Owners manual, plus much more for my 2018 HS-550 RK UTV Side-by-Side.
Submitter CBS Submitted 03/02/2024 Category Hisun
-
By bfairchild21
Please help I have a Massimo 400 buck that has an oil leak. The oil is leaking on the front side of the motor. It leaks out of a u-shaped steel pipe that has two banjo style fittings on it. I have tried using RTV and different banjo washers and have had no luck. It drips about one drip per second while it's running. I can't find parts for it at this time.
-
By Hillbilly
Hello everybody. I just tore a Yamaha apex snowmobile apart and I’m about ready to start fabbing up the mounting system for this thing. The Yamaha was in a stand alone setup. The gearbox was hard mounted to the chassis with the engine on four rubber mounts and that’s the way I’d like to build this too.
I ordered the secondary clutch from STM but it hasn’t arrived yet. The Yamaha secondary slid about 1/4” axially and I’m assuming that was to tolerate the fluctuation from the engine moving in the rubber mounts because of torque. I don’t believe the stm clutch has that slide action.
So my question is if I was to hard mount the rzr gearbox and leave the apex engine in its original mounts would the fluctuation from the primary under torque be bad enough to make the belts too far out of alignment ?
I’m not a fan of hard mounting the two together like Polaris does due to no ability to adjust the clutch alignment and the apex is sitting with fresh mounts installed in my garage as it sits. If I went with the rubber mounts that it already has I could be fabricating tomorrow. I’ve seen the kits available and I’m not paying that kind of money. Everything I need to fabricate this is sitting in my garage already.
Oh and the speed sensor. Anybody have to mess with this yet ? I have to assume the ratio from the apex gearbox and the Polaris gearbox are different. There’s no way I’d be that lucky
-
By Hugh
I want to change the transmission oil for my Sector Crew 1000 but cannot find the information on what type of transmission fluid this UTV use. I even called Hisun but they don't know it either. I get different answer each time I call. The service manual doesn't have any information on the transmission.
Thank you
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.