American Landmaster EV (Electric) Manuals
-
Similar Topics
-
By BWF
I have a 2011 or so Landmaster LM200. I cannot get it to start. I turn the key and nothing happens. The brake switch seems to be working, the ignition switch works. The Coil is new the Voltage Regulator is new and the starter relay is new.
I can connect the terminals on the starter relay and it starts right up and runs fine. I just can't get it to start by turning the key.
I am having a bit of trouble bleeding the brakes, not much fluid comes out at the calipers when I am pumping the brakes, though that an air bubble near the brake switch might make it not sense that the brake pedal is depressed.
I am at a loss, please help!
Brad
-
By Debbie Hogan
I realize this part is discontinued but im trying to find this exhaust pipe fir my dads 550. His brother who has since passed bought this mule for my dad who is now 90 and he is trying to fix everything on it. I'm willing to take a used one. A new one would be great if someone still had in stock. I'll take anything as long as it is in workable condition. If anyone has any ideas for me im open to hearing them. Thank you so much.
Debbie fm Texas
-
By Bedlam
Hello,
I have a 2019 Landmaster 550 UTV. Its been running good until now. The front axle wont engage. Where I live the temps have been well below freezing. The UTV is stored in unheated garage. And even the bottles of stored windshield washer fluid are frozen solid. So I am thinking that the front axle gear oil might be VERY thick and now allowing it to engage. Off the front diff is a small gauge wire running up to a connector. I put a test lamp to one of the leads and with utv running and 4 wheel switch on there is no voltage. However if I shut it off and have the 4 wheel switch engaged. and the crank it to start again the light gets a signal. for a second or two. I have to jacked up on rear and front and sometime the front will cut in and spin a few revs but the drops off.
Im hoping that someone can explain how the front engages on the axle. I assumed there was a fork or something that was engaged with 12 volts. But this wire is very small .This unit doesn't have a central fuse panel but I believe I have checked all the fuses.
Thanks in advance
Allan
-
By Dave MM1 SS
Given the current winter we're having, I was looking to add a plow to my L5. I got on the Landmaster site and ALL of the plows are listed as discontinued! I called and they said that they're in-between vendors to make em. Cycle Country usta make em, got bought by Kolpin, yadda, yadda ... can't find one.
Anyone know of or tried a universal plow/mount that'll fit a Landmaster SXS?
Thanks,
Buried in PA
-
By malenurse13
We've got the old Kohler motor out and the new Predator 459cc in!
But before we put the motor in there. I took some pics of the old wires. I'm hoping y'all can help me figure out what all these are for and what we need to keep.
There are a lot of inline fuses. And all the labels we can read say "12v pos" or "regulator/rectifier."
Main thing I'm looking for:
1. Wires to connect the stock ignition to the starter on the new motor
2. Wires for the headlights
If anyone can help me identify what all these wires are for, I'd appreciate the help!
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.