2020 Massimo buck 400 High idle issue
-
Similar Topics
-
By Sando
2023 Massimo Buck ran for minute then died. Key on all power to dashboard but do not hear full pump turn on like previously. Also no fire at plug. ECU?
-
By Joe Rizo
Hello All,
We have exhausted all possible troubleshooting steps, now we are in need of some help.
Vehicle cranks but will not turn over. Things we have either replaced or tested and are now known good:
1. Fuel pump (new)
2. Fuel sensor (new)
3. Fuel injector (new)
4. Battery (new)
5. Spark plug (new), spark tested
6. fuses (12v to all)
7. we have 12v at the injector module and 11 ohms resistance
8. we have fuel in the fuel line to the injector
9. we have fuel at the spark plug
10. we have injector pulse, verified with noid tester
11. brake safety switch tested (couldn't find a separate switch assuming it is using the brake light switch)
12. seat belt buckled and seat in place (again, not sure if this model has these features)
13. replaced air filter
14. replaced several air hoses
15. flushed radiator and replaced with diluted antifreeze
16. Drained and cleaned the fuel tank prior to replacing the fuel pump.
Any ideas, we are open to....Help!!
-
By Brianmart95
I recently purchased a new Kubota RTV520. When i try to start it i have to do the cold start procedure every time. Once it is running for a few minutes i can restart it without any issues.
The cold start procedure is turn the key to start position and let the fuel injection system turn on and stop. Crank for 10 seconds and if the unit doesn’t start, turn off and repeat the process 30 seconds later.
If it hasn’t been used for a week and i try to start it i have to repeat the cold start procedure at least 3 times until i get a successful start.
The dealer says this is normal and its not a malfunction on the engine. I feel like its weird for a new machine to have this starting routine.
I live in south Texas so the weather is not extremely cold.
Is ANYBODY having this problem? I am contemplating returning the UTV but i want to know if this is a common problem with the new 520 model.
-
By Pick a name
The Axis 500 will not shift into low or reverse. I have high when it should be in low and all the other places it is reverse. The gears in the shift cover are fine and I shifted it when the cover was off and yet no change (so it can't be the shifting mechanism gears). I t has been difficult to get it into low for awhile. But now it is either high or reverse, no neutral either.
-
By Rschrem
Hi, my 2010 Hisun will crannk but comes to a stop and only clicks. It has new battery and solinoid. Battery connections all seem good. Any ideas what the problem is?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.