Kinarfi Rides Again & Again & Again :)
-
Similar Topics
-
By lozomex
After a few days of heavy rainfall I got in my Sidekick and noticed that the belt seemed to be slipping as I was making my way out on a large property. I turned around and could barely make it back to my shop. After removing the cowelling I noticed about a quart of water drained out. I dried the area, the cover and checked the belt. No signs of dammage, belt looks great and no foreign debris other than water in the area. I put it back together and there was a definite improvement. The Sidekick is driveable now but the belt still slips but only at a higher speed and only when the throttle is punched. I'm wondering whether I may have inadvertently damaged it while it was wet and have ordered a new belt. I have looked on line to see if there is a guide or procedure, specifically for the CVT belt removal and replacement for the 850 but can find none. Does anyone have experience with this?
-
By Kenbaz
Hi Folks - Have owned a Coleman UT400 for two and a half years and use it daily for horse chores. It's been a good unit, just had to change sparkplugs frequently in the cold weather. Just the other day we ran it out of gas and have been unable to start since. Have posted for help on the Coleman portion of this board. Thanks in advance!
-
By Jfrosch
I have a Can Am Defender and purchased the Moose V-plow with hydraulic controls. I found the switch assembly to be big, bulky and having to cut the floor cover to install. I am finishing development of a replacement harness so the switches can mount in the dash. Is anyone else interested in this setup? I am sure the switch assembly is universal.
-
By TomW
I was driving the UTV the other day when it simply died. I was using the sprayer which might have drained the 3 year old battery and the stator didn't recharge it. I towed it to my shop and charged the battery . The next morning it cranked first time and I drove it home . I parked it and turned it off . I then tried to crank it and it would only make a weak click noise . I changed the battery and the voltage regulator but it would still only click. I noticed on the digital display that the reverse light was illuminated and would stay illuminated no matter what gear I selected . If I put it in low that light would light but the reverse light stayed on . Same thing for neutral . I shorted the two poles on the starter solenoid with the key on and it cranked up easily and idled fine. You could put it in reverse and it would move backwards and you could put it in low and it would drive forward. The entire time the reverse light stayed on . I checked the fuses and they all looked good . So lets say I get a new started solenoid . If I replace it and it now starts with the key what is the issue with the reverse light . Is it harmful? What else needs to be done to correct ? Any ideas out there.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.