Quantcast
Jump to content

kubota RTV 400 fuel filling cylinder


blacktrain

Recommended Posts

Replaced the injector, now when I turn the ignition on you can hear the fuel pump like normal but when the engine turns over it seizes up, pull the spark plug out and the cylinder is full of fuel, a lot of fuel, turn the engine over with the plug out and huge amounts of fuel blows out of the plug hole.   What have I done wrong?  I appreciate your help, thank you!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Mark T
      MY 400 is gutless. I would like to know if I can upgrade to a larger engine ?
    • By LongSun
      I can not find it on the board, so I'm afraid I'm the only cheapo on the forum.
      What is the fuel economy of the Hisun HS590? (I guess it is the same as the HS550)
      I count in liter per 100 km, but if you use MPG it's okay with me, but please tell if you use the US or UK MPG!
    • By ETHIEL
      Spark plug keeps fouling. after 10-15 minutes of running any ideas what to look fore 
    • By Nathon S.
      I have a Bennche 700 EFI Bighorn. I’ve recently been unable to get it to start. After a little troubleshooting I realized my fuel pump was not pumping fuel. This weekend I emptied the gas and replaced it with new. I replaced the fuel pump, fuel filter and fuel injector. I also replaced the battery, spark plug and made sure all my fuses and relays were good. I have confirmed that the float on the fuel pump is not obstructed. The UTV is about 12 years old and has less than 100 hours on it. It has not run in over a year.  Not sure whats going on?!? After doing a little reading I'm leaning towards it being an issue with the ECU or perhaps a faulty wire in the wiring harness. Anyone have any ideas on where to start looking or what I could be dealing with? Any help is appreciated, thanks in advance!
    • By packersfan
      I have a hisun 500 got from a auction and when turning a corner left or right it's a two hand job then when you left go snaps back.any help on what to look at would be appreciated.
      Also blows blue smoke until she gets warm then it's ok 
×
×
  • Create New...