Quantcast
Jump to content


Recommended Posts

Posted

Well I called the dealer and he was going to call the UTV Rep. and ask about headlight alignment. I haven't heard anything yet so I removed the assembly to check it out. I didn't see any way to adjust the headlight so I will try putting shims on the top mounting screws which will tilt the assembly at the top, giving me the hight I need . I'm posting a pic of the headlight assembly. I don't see any adjusting screws. Not sure what's under the black plastic caps but it didn't appear to be adjustment screws.

Randy 

headlight.jpg

Posted

Randy, Stop! no need to shim. The adjustment is that one phillips head screw you see in the picture at top right. Up and down adjuster screw. 

They seem to miss the detailed set-up at the assembly. They just do not check things very well IMO.

Hope I saved you some work.

 

Garrick

 

  • Like 1
Posted

Thanks Nods, That did it. I thought that might be a ground for a different application or something. I didn't see anything in the manual about it. Thanks again for saving me some work. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Topics

    • By esmarkey
      Hi, I purchased a used Cub Cadet 750 Challenger that seemed like the belt was slipping so I put a new belt in.  It still acts like the belt is slipping but now I am thinking it is the clutch? 
      What is the best way to remedy this problem? 
      Can the clutch be rebuilt?
      Are there aftermarket clutches available? 
    • By Burk
      I have a 2021 Axis(Hisun) 700 from Lowes. Will not start. Checked starter, solenoid, spark plug and fuel pump. Everything seems to be fine. The motor turns over and will try to start but just will not. Battery is also good. Frustrated!
    • By HISUN Sector 750 EPS Failu
      "Mrs. Smith" doesn't like how loud our Sector 750 is.  On a HISUN forum someone said the same thing about his 750.  I haven't given it much thought because I've been more focused on stuff that has broken.
      So, I used my decibel meter to check ours out.  4000 RPM, Low gear, under 20 MPH . . . . 97 decibels.  That's above most ordinances, even state boat noise limits.
      AI Overview Ninety-seven (97) decibels is considered very loud and dangerous to hearing with prolonged exposure, roughly equivalent to a newspaper press, a loud nightclub, or a snowmobile. At this level, damage can occur after just 30 minutes, necessitating hearing protection
    • By Hunterman22
      Can anyone please tell me or send a link as to how & where to hook up a code reader to my 2021 Hisun 500 Axis.  I have a 6 pin to a 18 pin  adaptor and the blue cord VAG KKL adaptor .Just not sure where or what to hook up to. Can I use your typical vehicle code reader or do I need to download something on a laptop or PC???
       
    • By Butch
      I have a AXIS 700 EFI Fuel pump pressure stays at 40 psi and when return line is blocked the pressure goes to 60 psi. and wll only run with return line closed. 
×
×
  • Create New...