Quantcast
Jump to content


FOR SALE - 2008 Polaris Sportsman 800 Twin EFI 4x4 - $2900


Recommended Posts

2008 Polaris Sportsman 800 Twin EFI 4x4 with only 573 original miles and 81 engine hours of use. It is a liquid cooled, 4-stroke, fuel injected monster of an ATV with a fully automatic transmission. It has four wheel independent suspension and on-demand 4 wheel drive meaning that when you need 4x4 you only have to flip a switch. The Polaris also has a speedometer with a digital display that shows hours, miles, trip-meter, 4x4 vs 4x2, and a tachometer. In addition, it has a digital fuel gauge. It can also be programmed to give you reminders when it is due for maintenance. Clear title on hand. For more information please e-mail me at [email protected]

post-972-0-37473500-1305298066_thumb.jpg

post-972-0-96197500-1305298098_thumb.jpg

post-972-0-31951600-1305298126_thumb.jpg

post-972-0-72630500-1305298141_thumb.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By William P
      After a short while of engine running the temp light comes on and the water in the radiator water is boiling., water level is ok pryer to starting engine. This is consistent. Coleman 400 bout 3yrs old
    • By weasel
      starts up you have keep rpms up for 5 minutes till it warms up then runs fine. But if it stalls wont start unless you unplug fuel pump and hold it to the floor till it starts then plug pump back in and run it till it warms up then it is fine all day.
    • By lmarkie
      I swapped out the Subaru motor for a Predator 670cc. If I remove the heat shield around the muffler, The stock muffler sits in there just fine with 1" to spare.
      Only problem is the exhaust exit is toward the back seat instead of out the back.
      Do you all think that the stock exhaust would be okay (just as effective) if cut a hole and welded a pipe on the reversed (opposite) end? Of course, plug the old exit end. Other option I thought of was to roll a tube 180° with a 7" center line radius and finish extention of 12" or so.
      Any thoughts?
    • By Sisco
      Does any have a part number for the fuel pump sock for a 2016 challenger 700 efi. Does not show on any parts diagram but the old pump has one on it.
    • By dave pasch
      Has anyone trouble shooted this transfer case? Full 12v to switch and case. No action inside case.
       
      Thanks Dave
×
×
  • Create New...