New Member from N/E Arkansas
-
Similar Topics
-
By Wilsobe17
I’m looking to add a lift kit for my 2018 Kawasaki Mule SX XC. Does anyone have a recommendation where to buy?
Im new with it. I don’t need to know how to out it together just some ideas on where to get it, how high, bigger tires possibly?
-
By Spencer Marks
Hello all,
I just finished replacing my front and rear drive shafts. I drained and put new dif fluid in the rear dif. I went to the local dealer and they told me the fill capacity of the front and the transmission as I want to replcae that as well but they could not tell me how to access the fill. One how do I access the fill for front dif and 2 is the transmission fill the same as the rear dif? I don't see a dip stick or fill for the transmission but all in same area.
Also, anyone can suggest a good shop/service manual for this bike?
Thanks
Spencer
-
By Stan Morton
My 2018 XG-850-SL starter died yesterday. The old part number from Kubota is E7153-11732 which has been superceed by part # EG881-63010. I am looking for an aftermarket starter because the Kubota retail price for the starter starts at $550 and upwards toward $850. If anyone has gone down this road before and has found an aftermarket starter ~ please share with me. We own a ranch and this thing is used every single day and is sorely missed when it is down for maintenance. Kind Regards, ~ Stan
-
By Terry B
We purchased this UTV less than 60 days ago and now I am having issues with drained battery. Used UTV for about an hour then stopped and when I went to start back up my battery was to low to start it. Jumped it and it started right up and ran fine back home. Tested charging and it’s not charging while running. Can it be anything other than the stater??? Can I look for something that I can fix Quik or does it have to go to the authorized service center to stay under warranty? It will take some time to get it in and out of service
-
By Modrob
Some time ago unit stalled going uphill towing a small motorcycle. Some smoke and smell of rubber burning. Removed belt and it looked ok but the case area was grimy with grease-like sludge. Cleaned it all out and installed new belt and front variator pulley assembly. Within a few minutes of running it was destroyed in pieces—this was low speed but uphill, with jerking/stuttering.
I then opened it up and removed the belt remains, but reinstalled the old belt. It runs again but again has the stuttering/jerking when accelerating from stop, or when slowing down to about 1-2mph…changed transaxle fluid and no difference.
Any ideas?
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.