-
Popular Now
-
-
Similar Topics
-
By RBonds007
I bought this SxS brand new. A couple of years after I bought it, I became disabled. Thus it has only 47 miles and around 16 hours of use. I have no need to keep the SxS. I am in Foley, Alabama. It is very hard for me to get in out of the Challenger. I would like to sell the set, 2019 Challenger 400, trailer and uninstalled winch (this was bought brand new as well, someone was supposed to help this newbie install and we never got around to doing this). I want $6500 for the whole set OBO (Serious offers only).
-
By Racing Dreamz
We're looking at the Axis 750 at Lowe's. It's the one with the two flat screens in the dash board. The Lowe's store tells me there are no "Service Centers" for them in our area(upper east Tennessee). Now, I've had Chinese products before, namely the ODES 650 UTV. It was a real piece of crap. Are these worth the $12,000 or should I go somewhere else. I like everything about the Axis 750 but skittish. I was told back in October of last year that Axis has not provided any Service Manuals on these models at all. And that the usual UTV repair places won't touch them. Anyone that has these, what kind of issues have you had? What should I look out for, just in case? Thanks in advance. :)
-
By JWS
Help Please!
Last year my Mule started running bad and was hard to start. NOT a battery or starter problem. I replace the carb with one of those cheap Chinese carbs from Amazon. Problem got worse. So, I replaced the fuel pump, one from Kawasaki, fuel filter and lines. Then replaced the fuel pump line to the engine. Finally bought a Kawasaki carb. Everything was ok till I filled the gas tank with fresh gas then it started running bad and hard to start again. The tank is clean. Gas is fresh, AGAIN. Filter is new. When running it has an occasional misfire. Managed to burn about a gallon out of the tank. Runs better. Replaced the gas cap in case it wasn't venting. No change. When running, if you try to go full throttle, it bogs down. The gas is good. I use it in my mower with no problem. The stater was replaced about one year ago and the flywheel cleaned inside. Still seams like a fuel problem but I'm at a loss. It's going back to the mechanic shop today. We use the Mule every day, live on a farm. It's never sat up. It has 1045hrs on it. New battery and starter.
Any ideas?
-
By lfredg
I have a Massimo t-boss 410 in shop will not start with injector installed, have to hold above hole to get to start , if unplug tps it will run if map sensor is out. replaced ecu, map,and injector.
Still no run, pulled the valve out of throttle body it runs high idle to an idle if out a 1/4 inch, still have hold injecter out to start, but with the valve thing out you can install map and injector for it to run. what do I need to do.
-
By JBF
I bought a pair of Rough Country pod lights and it comes with a 3 pin plug(black, white and blue) I want to hook it up to a lit 5 pin rocker switch but I don’t have a clue what pins do I need to connect it to. I wired it to the keyed switch. Chat GPT as good as it might be does not know what I am asking. Any help would be greatly appreciated!
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.