Quantcast
Jump to content


33x14 gorillas

Locoharleyman

By Locoharleyman
in Joyner UTV SxS Forum

 Share

Recommended Posts

Locoharleyman Explorer

Locoharleyman

Posted
Posted

Has anyone run any of the 33" gorilla silverbacks on their joyner? Just looking for some opinions on them. I ruined my 27" tire and I am going to replace all 4, do lots of trail riding in rocks, sand and love a big mud hole. Any thoughts?post-2149-0-97245200-1397614262_thumb.jpg

2scoops Proficient

2scoops

Posted
Posted

Pretty sure you won't be able to turn full lock. The tires will hit on the frame. I believe a few on here modified their frame somehow to make anything bigger than 30".

Unless you do at least 50% mud I wouldn't run these.

bruhaw Collaborator

bruhaw

Posted
Posted

Will be way too heavy as mentioned. With 30" Mudlite ITP's that I ran for just a little while they did rub some. I didn't modify frame and just had a bit of rubbing so you could get by. I now run 30" BFG All Terrains and not too heavy and they don't rub because the tread isn't aggressive.

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • BigWave
      2019 hisun won't run
      By BigWave
      I turned off the key and then tried to start it a minute later and it would not start. I changed out the fuel filter and the injector. still nothing. if i have the injector pulled out and close to the hole the injector will spray fuel into the hole and it will run but the minute you put the injector in it will die. any idea's please
       
       
      Bigwave
       
    • Gerald Dillman
      2008 Joyner trooper transmission parts
      By Gerald Dillman
      Looking for a output shaft for a Joyner trooper t2. Went to move the buggy after sitting all winter and it appears the out put shaft that drives the rear wheels broke off inside the transmission so looking for the shaft or a complete transmission if someone has one
    • Mike Jenkins
      2013 hisun 700 will not run, cranks fine
      By Mike Jenkins
      I have a 2013 Hisun with a 686 Yamaha engine.
      I purchased it from an individual and it ran fine as long as the battery was full.
      I replaced the stator and now it will not start (run).  It cranks fine, has fuel pressure, but will not fire up.  I replaced the coil, no luck there.
      a technician told me that it was the wrong stator and wants a mint to replace it.
      the wires all plugged in when I installed the stator.
       
    • didgeridoo
      Hisun Sector e1 Battery replacement: any tips?
      By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • Unhappy Kioti K9 Owner
      Any Kioti K9 2400 owners joining for class action?
      By Unhappy Kioti K9 Owner
      I own a K9 with 50hrs that has been in for repair more than once the farm.  Multitude of issues, trying to file lemon on it but interested in knowing if owners are organizing for a class action suit.  The dealer informs me there are “a lot of owners very unhappy with these”.
      Thanks

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...