Quantcast
Jump to content


Recommended Posts

Posted

I'm trying to put the front fuses and relays into a water proof box and half way threw I was pulled away and didn't get back to it till tonight and I'm lost...one relay only has two wires going to it and some how lost a relay...it's mess and I can't find a helpful diagram or drawing to help me and now I feel just stuck

Posted

I'll post a pic once I get home from work and I only found one wireing diagram and I couldn't understand it at all....wasn't even sure it had relays on it

Posted

Too late to do this now, but when ever I start a job such as this, I pull out the smart, Irritating as hell, smart phone and take a hand full of photos so I have something for a reference.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Karlibob
      I have a 2020 800 sx with about 16 hours on it.  From day one I have heard a clunking noise from the front end going over bumps.  Has anyone else experienced this?  Also this past weekend while out riding I heard a noise that sounded like the dump bed bounced three or four different times, again has anyone experienced anything like that.  Thanks, gary
    • By Jon Spruill
      Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
    • By Paul L
      When I am driving at 30 to 40 mph on the highway, the display will change from H (high) to R (reverse).  It does not actually shift into reverse, it seems to shift into neutral and starts losing speed and the gas pedal has no effect.  After the rpm/speed drops for 5 seconds or so, it changes back to H and runs fine for another minute or so.  You have to try to drive it at less than 5000 rpm or so, to try and keep this from happening.  Any ideas on what the problem might be?  It only happens at the higher speeds.
    • By rdborra
      I had to remove the relay for the dump bed due to it popping the fuse for main key power. I have tried to find a short but nothing seems to out of normal. I also disconnected the dump motor and switch and still pops the fuse. Also, when the machine is warmed up i get about 5 to 10 of work out of before it stalls. Once I can get it to start again I have to use the choke to keep it running. 
    • By carl baney
      have a 2021 tracker 800sx noticed locks on box when u fasten both sides of box are cracked anyone else have this probl
×
×
  • Create New...