Quantcast
Jump to content


2009 mule 610 keeps blowing fuses

nbbforrest

By nbbforrest
in Kawasaki UTV SxS Forum

 Share

Recommended Posts

nbbforrest Newbie

nbbforrest

Posted
Posted

my 2009 mule 610 4x4 keeps blowing the main fuse. the dealer said a controller needed replacing and it was not cheap. it cranks up and after

about a minute the oil light will come on and then the fuse blows.

kind of a novice when it comes to diagnosing electrical problems.

has anyone had this same or similar problem. Or, do you know anyone that has.

any help will be appreciated.

  • 1 month later...
nbbforrest Newbie

nbbforrest

Posted
  • Author
Posted

I took it to shop and the voltage regulator was over charging causing the 30 amp fuse to blow. also burnt out the controller. had to replace the controller and regulator. problem solved.

  • 4 years later...
  • 3 months later...
Grizzly Newbie

Grizzly

Posted
Posted

HELP!  My 2009 Kawasaki 610 Mule blows the 30 amp fuse, with all switches off.  Replacement fuse blows immediately.  Unhook regulator, no fuse problem.  Plug in regulator, fuse blows.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Topics

    • brewski
      installing light bar on kubota rtv 1100 x
      By brewski
      I just purchased a 2025 kubota rtv 1100 x cab esd esnting to install light bars on the roof it appears to be prewired for lights how do lights mount and what kind of switches do i need
    • mike.s.
      Kawasaki mule model 2010, 4x4, gas motor, sell or trade
      By mike.s.
      SOLD 
       
       
       
       
    • Big Red Dog
      2009 Rhino 700 won't idle well
      By Big Red Dog
      Bought my 2009 Yamaha Rhino, (fuel injected of course), recently from the original owner. Only had 500 miles and 70hrs. Starts reliably, however, it will not idle but about 50% of the time. Also, when driving slow in low or high, that is to say, relatively low rpms and below about 10 mph, it bucks and almost wants to die..... not smooth at all. However, at speed (say 12-15 mph or more) it runs very well, like it should. Any ideas?
    • Pajer
      Winch fuse location on a 2021 ut400
      By Pajer
      Does anyone know where the winch fuse is located on a 2021 ut400? I’ve been working on the solenoid because the winch will only go in one direction..
      Either in or out depending if I reverse the leads on the solenoid. Now I have no power to the solenoid and it appears I blew a fuse. Winch is supposed to have a 30 amp fuse.
       
      i checked all the fuses in the fuse box near the battery and the 30amp fuse hanging in the compartment. Everything is good there.
      but I can’t locate any other fuses. Any help would be appreciated.
    • jugliner
      2020 UT400 surging after sitting for winter
      By jugliner
      I have a fuel injected UT400 that will start and idle, but surges and sputters at higher speed.  It has been sitting for 2-3 months and was fine when parked in garage.  I assumed it was a fuel/air problem and pulled the throttle body and cleaned it up.  I've ended up replacing the injector, IAC valve, MAF Temp Pressure Sensor, and fuel filter.  I've also checked the spark plug, Still surging.  I reset the ECU after every component swap.
      I plan to pull the throttle body again and look evrything over for any visible leaks, etc.
       
      Any suggestions would be appreciated on next steps.   The problem developing after sitting makes me think it should be something simple, but I'm stumped.  BTW the fuel was fresh and treated with Stabil.
       
      Thanks.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...