Larry The Cable Guy Nails It On.....
-
Popular Now
-
Similar Topics
-
By Burk
I have a 2021 Axis(Hisun) 700 from Lowes. Will not start. Checked starter, solenoid, spark plug and fuel pump. Everything seems to be fine. The motor turns over and will try to start but just will not. Battery is also good. Frustrated!
-
By RBonds007
I bought this SxS brand new. A couple of years after I bought it, I became disabled. Thus it has only 47 miles and around 16 hours of use. I have no need to keep the SxS. I am in Foley, Alabama. It is very hard for me to get in out of the Challenger. I would like to sell the set, 2019 Challenger 400, trailer and uninstalled winch (this was bought brand new as well, someone was supposed to help this newbie install and we never got around to doing this). I want $6500 for the whole set OBO (Serious offers only).
-
By kmiller7351
Trying to get running a 550 Colman running but I think head gasket went bad. Do i just replace with new gasket, clean up and replace or is there more to it?
-
By dryvalleyboy
The steering shaft is slipping,I checked it's tight as the bolt will take at the u-joint.. Is there a slot or something it may have jumped? This is right after the shaft enters the area under the hood.Thanks.
-
By tsheh4
Question for the audience, does anyone know the differences in the hs400 and hs500 primary belt clutche and the wet clutch? I have been told the 500 and up engines use a clutch that is interchangeable with yahmahas, but the 400s have a different part number as far as I can find. Is this maybe just different weights in the clutch? Also does anyone know what the factory weights are? Went for a ride in my 400 this week and looking to see if I can get a little more out of her as far as holding higher rpms and maybe getting a bit more aggressive clutch engagement sooner.
-

Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.