Quantcast
Jump to content


Hisun Sector 750

Rangerider45

By Rangerider45
in Hisun UTV SxS Forum

 Share

Recommended Posts

Rangerider45 Apprentice

Rangerider45

Posted
Posted

Hi,

I'm new to the forum and live in Idaho.  It's getting colder, so I'm curious if anyone has installed a cab heater in their Hisun? I went to the dealer and they want $800 bucks and maybe more so I ordered a hot rod heater from Summit Racing. Thought I would see if anyone has experience they might share before I begin.

Charlie...

IMG950933.jpg

  • Like 1
  • 1 year later...
Rangerider45 Apprentice

Rangerider45

Posted
  • Author
Posted

Hi Nativespud. 

What kind of heater did you install on your Sector? 

I installed a generic hot rod heater from Summit Racing for $150.00 and it works very well.   It even defrosts the windshield and door windows without tubes being routed to the windshield.  By running the coolant through the radiator as well as the heater core it keeps the engine running cooler than normal.   It easily warms my cab, but would do a better job if I put a shut-off valve in front of the radiator.  That would allow the motor to heat up a little more.  I think running only the heater core helps cool the engine a lot as well so there should be no concerns about the engine overheating and causing problems.

Thanks for the reply...

Charlie

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • rdc
      Looking for the left side shaft carrier where the rear bearings go for a 2014 1100cc sand viper, I understand an 800 cc carrier will also work.
      By rdc
      I posted this before , but I had the year wrong. The part I need is for a 2014, I don't know what all years will work, but I need the 2 bearing style with the spacer in the middle. It looks like this pic. If anyone has one I'll buy it rite away. my email is [email protected]. Thanks, RC

    • MilSurpYinzer
      New Mexico etc
      By MilSurpYinzer
      I heard there's several off road festivals out that way. One or two post apocalyptic, the rest just rev and run. Anyone know a good one that offers camping? Any advice for out of state people like hauling, legality, and where to stay?
      Ideally me and the missus would be down for camping out and setting up shop somewhere nearby. That way we can just wake up, load up, and ride.
    • Burk
      2021 Axis(Hisun) 700 Will not fire up
      By Burk
      I have a 2021 Axis(Hisun) 700 from Lowes. Will not start. Checked starter, solenoid, spark plug and fuel pump. Everything seems to be fine. The motor turns over and will try to start but just will not. Battery is also good. Frustrated!
    • HISUN Sector 750 EPS Failu
      Is Your HISUN Loud?
      By HISUN Sector 750 EPS Failu
      "Mrs. Smith" doesn't like how loud our Sector 750 is.  On a HISUN forum someone said the same thing about his 750.  I haven't given it much thought because I've been more focused on stuff that has broken.
      So, I used my decibel meter to check ours out.  4000 RPM, Low gear, under 20 MPH . . . . 97 decibels.  That's above most ordinances, even state boat noise limits.
      AI Overview Ninety-seven (97) decibels is considered very loud and dangerous to hearing with prolonged exposure, roughly equivalent to a newspaper press, a loud nightclub, or a snowmobile. At this level, damage can occur after just 30 minutes, necessitating hearing protection
    • Hunterman22
      2021 Hisun 500 Axis. Reading Codes??
      By Hunterman22
      Can anyone please tell me or send a link as to how & where to hook up a code reader to my 2021 Hisun 500 Axis.  I have a 6 pin to a 18 pin  adaptor and the blue cord VAG KKL adaptor .Just not sure where or what to hook up to. Can I use your typical vehicle code reader or do I need to download something on a laptop or PC???
       

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...