Quantcast
Jump to content

2007 prowler xtz 1000 shifting issues


Recommended Posts

Sometimes when I go from neutral to high, the machine will not move and I have to move the shift lever back and forth until it go into gear, and the strange part is when I go from reverse to high to low, it stays in reverse and I have to turn the machine off, move the shift lever a few times then I can start and take off in drive, please help.

Link to comment
Share on other sites

  • 1 year later...
On 3/14/2020 at 11:37 PM, Buggs63 said:

Sometimes when I go from neutral to high, the machine will not move and I have to move the shift lever back and forth until it go into gear, and the strange part is when I go from reverse to high to low, it stays in reverse and I have to turn the machine off, move the shift lever a few times then I can start and take off in drive, please help.

I have the same issue and cant figure it out. Did you have any luck fixing yours?

Link to comment
Share on other sites

  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Ermd ttk
      Hello friends,
      I got my ODES Ravager UTV yesterday and after a couple of hours of driving when I go downhill I heard a strange loud noise a couple of times, like a gear skipping or maybe something from the differential.
      It doesn't always happen and when it does it is heard for a few seconds and then it goes away and everything works normally, I'm worried if there could be some major malfunction or what could be the problem if someone can help me?
      Thanks a lot.
       
    • By Steve B
      My "R" light on the dash will not go out when I take the UTV out of reverse and put it into any other gear. Is this just the light switch issue or will this effect engine performance in the other gears?
    • By lonerider98
      At the end of last year my Coleman UT 500 will not go into reverse. I can hold it over toward the reverse to move it nut it won't lock into reverse. Anyone have this problem? Winter is just about over and going to have to get this resolved. Thank You!
    • By packersfan
      I have a hisun 500 got from a auction and when turning a corner left or right it's a two hand job then when you left go snaps back.any help on what to look at would be appreciated.
      Also blows blue smoke until she gets warm then it's ok 
    • By alevins
      Good day all, 
      searching here but cannot find the answer,  Hisun been working fine and now reverse limiter seems to be engaging and cannot back up, cannot find a clear solution to disable the limiter. found a possible relay?  not sure which one or to cuut a wire at ecu but a picture or diagram would be helpful
      thank you for any help in advance
×
×
  • Create New...