Quantcast
Jump to content

Massimo 500 Won’t crank with key


Recommended Posts

Well, just spent some time looking for a loose ground. The only ground wire I could locate was 3, attached on the frame on the driver's side near the fuel tank. There's a ground wire attached to the starter, which was tight. I still have to hit the starter a few times to get it to turn over. Is there any way to diagnose a bad ignition switch? I checked the battery, and it was showing 12v with the engine off, and 14+ when running.

Link to comment
Share on other sites

  • 5 months later...

I just brought home a 2023 TBoss 500...Runs great and then I parked it,,,, The next day I got in turned the key,,, Waited a minute then tried to crank it over,,,, Nothing!!!I thought maybe its in thewrong gear or something,,, I shifted to high then low then neutral...All did nothing,,, Then waited a minute and tried again and it fired right,,,, What is going on with this,,?  Any ideas ... It's just one day old,  virtually brand new!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • By Buddee
      Put a new carb on the 500 to replace the leaking OE one.  Machine idles fine and mid and top end runs great.  It tends to have a hesitation right from the start - bottom end.   Thinking it may be the air/fuel screw??  I didn't do anything with the carb out of the box and is it direct replacement for my machine.  Of interest is the manual choke doesn't seem to work very good now.... wonder is it getting too much air?
       
      Any help appreciated!
       
       
    • By htrotte
      #1   While troubleshooting an issue with temp warning light I discovered another temp switch mounted in the pipe going to the head  The two switches are literally 6 inches apart.  Does anyone know what this third switch is used for?  If i can figure out how I will post pictures.
      Author #2   Finally got the pictures took.  See the photo and tell me if you know what the switch on the right is.
      It looks to be factory and I know the girl who bought it new and she didn't install it.
      I can't find anything on it in any manual i have looked at.  Any help would be appreciated.

    • By joel b
      i purchased a brand new massimo tboss 410 and from day 1 it wont operate in reverse.  When i pop in reverse and give it gas it will die out.  when i pop in reverse sometimes in will die right away (before giving any gas) and 1 time out of 100 when i pop in reverse it will operate perfectly fine.   and yes, it operates perfectly dine in normal drive H and L.  any thoughts??   when i called the dealer i got it from they had no idea.  
    • By Randyh79
      Is there a way to adjust the brightness of the dash light on aHisun 750 sector?
×
×
  • Create New...