Quantcast
Jump to content


2013 Bennche Bighorn 500 no 4 wd

David Hopkins

By David Hopkins
in Bennche UTV SxS Forum

 Share

Recommended Posts

David Hopkins Rookie

David Hopkins

Posted
Posted

I have a 2013 Bennche Bighorn 500 that will not go into 4wd, I have replaced the switch already so looking to replace front servo. Does anyone know where I can get a u tube of how to remove and install the servo???

thanks in advance 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Tim n Deb
      2015 Massimo stalled and wont start. oil, new plug, getting gas verified. cranks but does not start
      By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • GBarney
      d1105T install in rtv 1000?
      By GBarney
      Recently bought a 2010 RTV 1100 with bad engine. a d1105T out of a toro 5400 just came available locally. Looking for info on if anybody has installed the turbo version of this engine, what challenges/ problems were encountered, how it turned out.
       
      Looks like nobody has any insight. I will complete installation and report back as to how it went, how it works, and what's involved.
    • Kevin Ullman
      2013-2016 Polaris RZR 570 Service Manual
      By Kevin Ullman
      View File 2013-2016 Polaris RZR 570 Service Manual
      2013-2016 Polaris RZR 570 Service Manual
      Submitter Kevin Ullman Submitted 04/23/2025 Category Polaris  
    • Mike Jenkins
      2013 hisun 700 will not run, cranks fine
      By Mike Jenkins
      I have a 2013 Hisun with a 686 Yamaha engine.
      I purchased it from an individual and it ran fine as long as the battery was full.
      I replaced the stator and now it will not start (run).  It cranks fine, has fuel pressure, but will not fire up.  I replaced the coil, no luck there.
      a technician told me that it was the wrong stator and wants a mint to replace it.
      the wires all plugged in when I installed the stator.
       
    • Karlibob
      2020 Tracker 800 sx front end noise
      By Karlibob
      I have a 2020 800 sx with about 16 hours on it.  From day one I have heard a clunking noise from the front end going over bumps.  Has anyone else experienced this?  Also this past weekend while out riding I heard a noise that sounded like the dump bed bounced three or four different times, again has anyone experienced anything like that.  Thanks, gary

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...