Challenger 550 Clutch Problems
-
Similar Topics
-
By great8redsfan
Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power. They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil. Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm.
-
By donwan
View File 2017 Hisun Strike 900 Service Manual
Here's the service manual for the 2017 hisun strike 900.
Submitter donwan Submitted 05/29/2024 Category Hisun
-
By Keith k
Just got this kymco 450i Uxv from a guy, drove it around before I paid. Got home drove around town a little while the next day and it started squealing and amd didn’t want to go. Got to looking at the clutch, that’s were the noise is coming from, the primarily sounds like. Maybe a bearing in there cause the grinding noise and it only makes the noise when you go to move.
-
By Booker
I appreciate any advice anyone can give.
I am working on a Challenger 750 that the drive belt broke on.
Removed the side cover and spun the primary drive sheaves. Something was clunking.
Took it off and pulled the outer cover and all of the rollers were out of their spot and clunking when rotating.
I noticed these rollers are not round. They have 2 different flat spots on them. Are they supposed to be round?
If not, How do they go back in? Flat side down, up, I don't know.
I apologize for not explaining this properly. I was just hoping someone has seen this before.
-
By nods
Less than 40 miles can barely start. Dealer is working with Hisun on a number of other issues on this UTV. Can not get clear info on the meaning of these E codes this is getting. Anybody have some clear info for me?
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.