Quantcast
Jump to content


American SportWorks Trail Wagon Killing Batteries

mikemc53
 Share

Recommended Posts

mikemc53 Rookie

mikemc53

Posted
Posted

I will do my best to describe this so bear with me. The UTV is a Trail Wagon (American Sportsman) but the make might be immaterial with this problem. I have now gone through three batteries in a few months and the last two just a week apart. Here is the sequence:

I use my utv lightly almost every day but that is only about 5 months a year as I live in Florida and Michigan and the utv stays in Michigan over the winter. I always store the unit and trickle charge the battery, and this does not seem to be the issue - let me explain. Last fall, just before I left for Florida, the  battery died and it was a few years old so I wasn't concerned. It did die without a lot of warning as I didn't get the gradual slowing of the start process that usually precedes the battery death, but I didn't think much about it. It died completely and would not take a charge or a jump so I bought a new battery and it worked great. I only drove it once or twice and then put it up and left for Florida. Came back a few weeks ago and the battery was in good shape on the trickle charger. Put it in and everything went well...for about a week. Without warning the battery went dead (10.8V) and would not take a jump or charge. Like the previous year there was no gradual wearing down, it just quit. I chalked it up to a cheap battery and got another battery. This one was strong and the utv started up like always...for about a week. Same thing with no warning and this time the battery was at 11.4V. I'm thinking bad alternator/rectifier, at that time but I needed to check it. I charged it, though it again did not seem to want to charge, at first, but then I got it to 12.6V so I gave it a shot. The minute I turned the key it died - no starter sound at all. I jumped it with my tractor and it started. I immediately put a voltmeter on it while it was running and it was up around 14.4V which tells me the alternator part seems to be working. I let it run for a bit and shut if off. Next morning...dead (11.4V) and struggled to take a charge but I did get it to 12.6V again so I went to hook it up. Put the positive cable on first and just for kicks I checked the voltage before I hooked up the negative cable and it was 11.3V - just from hooking up the positive. I got another older battery to take enough of a charge (12.8V) to try it again. This time I hooked up the negative first and checked the voltage - 12.8V still. Hooked up the positive and checked the voltage - 10.8V. This makes no sense. Simply connecting the positive cable completely kills the battery without ever turning the key or anything. And when it kills the battery it really kills it. They usually don't want to take a charge so something is really busting them.

I am at a loss...thoughts?

  • Alex changed the title to American SportWorks Trail Wagon Killing Batteries
  • 3 months later...
W B Enthusiast

W B

Posted
Posted

When you have the battery at full charge, reach  down and feel the solenoid and starter. Sounds like a hefty drain on the battery. I'm thinking a shorted solenoid but not enough to crank the starter. If shorted you will generate some heat.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • rdc
      Joyner 1100 oil pressure problem.
      By rdc
      I have a 2007 Joyner 1100 sand viper and  before it even get's to where the thermostat opens up the oil pressure get's so low I have to shut it down. What could fix this ? I thought about adding an oil cooler with fan, thicker oil, or removing the thermostat. Any advice?
    • jertex
      Shift cable problem, 2017 Stampede 900, need advice
      By jertex
      I bought a 2017 Stampede 900 last fall that was new, old stock with less than 5 hours on it thinking that I would be getting a relatively trouble free UTV as compared to buying a used Polaris or CanAm, or Honda, etc. It's been a little quirky, but reliable. What I thought was just a minor issue with this model, the difficulty in shifting between R, N, L, H, etc., was just a characteristic of this model is now a big problem. I had to climb two very steep trails to get to the upper meadow of our hunting property, which seemed to stress the UTV more than usual since I was carrying some lumber to work on a platform for a hunting blind, and when I went to shift into park, I felt something give and it would not shift out of low, but it did move up into high gear.  I couldn't get it to shift at all at that point and the shifter felt mushy for lack of a better word. I was able to get it down to the lodge and when I investigated, I discovered that the straight, metal tube portion of the shift cable had bent to almost 90 degrees (see pics). I'm positive that it had already had some deformation that had happened previously and it had the right amount of resistance to bend to the point where it was unusable. 
      I have two questions:
      1. I suspect that there must be some other issues that makes this UTV difficult to shift, and I'm wondering if this is a common problem and if someone could enlighten me on what could cause this to be difficult to shift?
      2. Have any of you had this happen and if so, how difficult is it to replace the shifter cable?
      Any other advice is welcome, this is the first UTV that I've ever owned, so I don't know much about working on these or maintaining them. I'm relatively capable when it comes to working on my own vehicles in general, and I'm not afraid to take things apart and get my hands dirty.
      Thanks in advance for any insight, I'll be traveling most the day so I won't get a chance to look at replies until this evening.


       
    • Kyler
      Trail wagon TW450
      By Kyler
      Put new fuel in this thing, new battery I can get it to turn over but want stay running it’ll try to run with starting fluid but shuts right back off what could the problem be?
    • Eman85
      Best place to find info on Hisun or Massimo UTV's
      By Eman85
      I have been searching and can't find much info on these units. Pretty surprising as every other thing I own I find a lot of info on. Researching for tech info and such it's like no one owns any of these yet I see them everywhere. 
    • Jeff freeman
      Utv wont start and broken fuel injection wire
      By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...