Search the Community

Once i get the cylinder honed, the only remaining problem is the crankshaft shim.. And i have a few questions. 1. In the manual it gives a solution to the problem i'm having of the crank NOT spinning when the cover on (by hand). 2. And i just can't wrap what's left of my brain around the instructions, i guess use a caliper to measure? (instructions circled in red) (my brother has been helping me, he's fairly knowledgeable with this stuff, but more Diesel engines than anything) and he says to use a dial indicator set up, and to use this* as a spec for end play. and that would help us get the measurements needed in picture #2. 1st pic is the runout. But is it the same as crankshaft end play? 🤔 2nd pic is of the instructions (solution) to get the correct shim. I don't know, maybe this makes sense the way i wrote it. Thanks, Travis.

Hi, I am a few steps away from completing my Engine Rebuild. anyway, I'm trying to figure out how much axial play the crankshaft is supposed to have w/ gasket and cover installed. so i can figure out how to " Re Shim it.. KAWASAKI MULE 550 KAF300C5, 2001 yr Mod. thanks!!!!!