Quantcast
Jump to content

Coleman 400 UTV won t start


Kpw

Recommended Posts

My Coleman 400 UTV is about a yr old  started it up yesterday parked it outside..later on the day it would not start. Has gas, cranking trying to start but won`t turn over. looked at trouble shooting tips and it said check spark plug. Where is the sparkplug located and any other suggestions

Link to comment
Share on other sites

You say cranking but won't turn over? Do you mean it won't fire, or it won't crank?

First check your battery voltage is about 12.5V, make sure you have fuel in the tank.

From there you can check for spark the spark plug is on the back of the motor under the bed. Connect an inline spark tester and make sure you have spark when cranking.

Then I would remove the fuel injector and verify fuel pulses when cranking.

If all that's good I would check the valve lash & timing.

Link to comment
Share on other sites

  • 2 weeks later...
  • 7 months later...
On 7/18/2023 at 2:41 PM, Carrie said:

 My Coleman runs and drives but it loses power when going up a hill is there anything that would cause this to happen? It won’t barely pull itself up hill it runs fine other than this issue.. please help 

I just purchased a 2021 Coleman UT400 and had a similar problem. Now the manual states the grade should not be more than 15%. The hill on my property, and there is multiple ones, is probably around 35%, but I got it to get to the top, about 30 +/- feet or so. I did read in the manual that when going up hill, to put the UTV into 4WD for better traction. I have to try that to see if by having both axles pulling, the UTV will not struggle as much.

Information on climbing hills in my manual is on page 7-10.

I'll update, but give it a try and see if it helps.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By MOTORHEAD1959
      ATV just clicks when trying to start. Battery is good, has a new starter, and all the wiring looks good. any suggestions on where to go from here? thanks 
    • By Ermd ttk
      Hello friends,
      I got my ODES Ravager UTV yesterday and after a couple of hours of driving when I go downhill I heard a strange loud noise a couple of times, like a gear skipping or maybe something from the differential.
      It doesn't always happen and when it does it is heard for a few seconds and then it goes away and everything works normally, I'm worried if there could be some major malfunction or what could be the problem if someone can help me?
      Thanks a lot.
       
    • By buckrub
      Hey guys! Newbie here. I'm an old man who's better with plowing a mule (4-legged kind) than these newfangled beasts. I, and a friend of mine, just bought new Coleman sxs and are having to finish the assembly. I've been reading on this site and I'm falling on the mercy of you experts. The only way I'm an expert is that an "ex" is a has been, and a spurt is a drip under pressure. LOL First off, the 2 buggies have no ignition switches. They seem to mount on the dash, not the opening in the steering wheel shaft cover, so we ordered new ones that are supposed to fit. They are 8 inches long, and have a 4-wired white plugin which is slightly rectangled when looking at the end of the plug. The trouble is there's nothing to plug into. There is a three-wire grey plug close enough to reach the four-wire plug, but of course, they are not compatible. 
      Secondly, the blinker, light, ect. unit on steering wheel just spins around when touched. I see no way in heaven or earth to secure it. I've looked at a diagram on the Powersports site, but can't detect how it mounted. Fellows I'd be so grateful for any help with this. Me and my mule will even plow your garden for free, for your help. LOL 
       
    • By ETHIEL
      Spark plug keeps fouling. after 10-15 minutes of running any ideas what to look fore 
    • By AlaskaTrail
      Hi All,
      New to UTVs and recently accuired a ut400 from our local Alaska Commercial Co. and had a questions regarding the transmission fluid. I have had a squeeling noise, sounds like a teapot, that recently started after being driven for a few minutes. The manual says to change the fluid at 500 miles, so I was thinking maybe its just time for this to be changed. Other then that I cannot find any information regarding the type used. While reading through these forums, I seen someone put that the transmission is lubricated with the engine oil. Is this true? If not what should I be using and where can I find the information to change it out? Any input on this would be greatly appretiated!
      Thanks in advance
×
×
  • Create New...