Quantcast
Jump to content


Recommended Posts

Posted

the owners manual is a big help....not...

Error code
In the event that an error code is displayed instead of
the hourmeter or the odometer, note the error code and
then turn off the engine. Restart the engine next. If an
error code is displayed again, consult your KUBOTA
Dealer.
 
 
  • 1 year later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Topics

    • By Niko
      Need new pistons, rings, connecting rods and bearings for rebuild, dealer cannot get .5mm over pistons.  Looking for best aftermarket supplier.  Suggestions are appreciated.  Thank you
    • By Sammy
      Runs fine just putting around the yard. Get it out on the road and about a half miles it runs out of gas. Let it idle for a few minutes and it will run for another half mile and do it again. Replaced both fuel pumps and filter. Does anyone know if I can get rid of the factory fuel pump?
    • By Bucky4444
      Has anyone found a decent replacement for the factory mirrors on a 2020 1100C?  My 2011 1100 and 2020 1100C both have the same mirrors and Kubota hasn't made one improvement to the design during those years.  Haven't checked the newer models so maybe Kubota finally woke up. Mine are definitely in need of improvement.  . 
    • By Kakha
      Greetings to the forum participants, my Kubota RTV 400 has stopped starting. More precisely, it works intermittently. Please advise what could be the cause.
    • By carbdoctor
      I have an 850. It’s been overheating. The electric fan is not kicking on. I see the temperature switch going into the radiator, but there’s no wire plugging in to it or none to be found in the area. i’m thinking I might’ve hooked on a branch and it ripped out the harness on that part. Does anybody have a picture or no where that plugs into on the harness? On the top of the firewall, I did notice some plugs that have nothing plugged into it. I was wondering if it’s a harness that goes from there down to the radiator that was pulled off


×
×
  • Create New...