Quantcast
Jump to content


Hisun Strike 250 complete electrical failure


Go to solution Solved by Cody Brown,

Recommended Posts

Posted

Not sure how better to describe it other than no lights, head lights, dash lights, no cycling of fuel pump when the key is turned, no starter activity, etc.  checked all fuses in the fuse box under the driver seat (anyone know of any other fuses I might have missed?).  Hooked starter up directly to the battery for a split second and it cycled fine.  Same with the radiator fan.  This machine was running fine during a ride, and my son hit a bump, it died, and never came back.

Posted (edited)

Sounds like a loose connection somewhere in your primary 12 volt supply or ground. Do you have a service manual with a circuit diagram and a good volt meter? I'd start at the battery, test for 12 volts from the positive terminal to a ground somewhere on the engine or frame. If you read 12 volts, your ground is probably OK. Then start testing from your battery ground to the ignition switch to see if you're getting 12 volts there. Someone with other ideas will hopefully chime in. You'll need a wiring diagram to check much further than that.

Looking at the diagram for my 550, it looks like the horn is hot all the time, yours may be also, does it work with the key off?

Edited by Dale Stansbery
Additional ideas
  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Topics

    • By Sammy
      Runs fine just putting around the yard. Get it out on the road and about a half miles it runs out of gas. Let it idle for a few minutes and it will run for another half mile and do it again. Replaced both fuel pumps and filter. Does anyone know if I can get rid of the factory fuel pump?
    • By didgeridoo
      Hello, All!  I've decided to replace the traction batteries in my 2018 Sector E1 with a 48V Lithium set. They may be expensive, but I figure the Discovery Dry Cell are, too. I am not looking for the max driving range, as I have never received near the brochured range to begin with, but a good mix of charge/ get work done/ charge is what I am expecting.
      I have settled on the 48V EAGL kit from bigbattery dot com. Each battery pack provides 30Ah. The kit ships with a charger, as well. The packs would be physically connected in parallel (using a busbar) to one another, maintaining the 48V voltage, but together would be able to provide the amp draw the buggy pulls when going up hill or towing a rake (rated 320 max continuous Amps). This is in comparison to the serial connection the eight 6V lead batteries. Each of the EAGL batteries looks to have its own BMS; am I correct in thinking I will have to use their included charger rather than (simply) changing the onboard charger to lithium mode? The chemistry of the pack is LiFe PO4, for what it's worth.  I haven't torn anything apart yet (to diagram), so  I am not sure how the dash will interpret the AMP draw, but the kit I am looking at includes a dash mounted charge indicator.
      If anyone has completed a similar conversion, do you have any tips? Specifically, how did you remove the original batteries, and how did you secure the new ones? I am guessing that almost any change from the stock batteries would involve at least some modifications. Any tips would be appreciated, especially things I may have failed to consider. Thanks!
    • By Firewalker918
      I have a 2021 UV34XL and I am kind of looking to change it up from the orange wheels and maybe do a wrap?  Please share photos of any XLs that has been modified to look better and any seat covers recommended.thanks
       
    • By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


    • By JohnnyB
      My Massimo 500 will not start. I’ve checked all the obvious things. It turns over just fine. fuel, spark, fuse box are all good. I can’t figure it out. Any ideas would be greatly appreciated. Thank you.
×
×
  • Create New...