Quantcast
Jump to content


Carb tuning

huunz

By huunz
in Joyner UTV SxS Forum

 Share

Recommended Posts

huunz Collaborator

huunz

Posted
Posted

I've got the 650 Spider, the one with the two cylinder engine and side draft carb. The right plug was cold/not firing, so I changed the plugs out (thanks Silverbullet for the plug type, and this forum for how to do it) and then tackled the intake. When I pulled the air filter tube off, there was standing gas in the carb inlet. Because of what I found, I took off the carb top, cleaned the needle and seat, although they looked fine, and put it back together. I started it up and it ran great. BUT.... if i wanted to change the needle and seat, say to a Viton setup vs. the solid needle, where would I look? Do any Japanese bikes or quads fit? I found the oil filter is the same threads as my 91 Nissan 2.4L pickup, so other parts might cross as well. One issue i can see is that carbs have not been used on cars in the US since about 86.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Tim n Deb
      2015 Massimo stalled and wont start. oil, new plug, getting gas verified. cranks but does not start
      By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • CSM_Retired
      Kioti UTV SxS Forum
      By CSM_Retired
      This is for all of you Kioti Off-Road UTV, SxS (Side by Side) owners. Discussions about Kioti Off-Road specific topics including the Kioti Mechron, K9, 2400, and 2440 models. 
    • Ed Michael
      Older Landmaster LM 650 Fuel Problem
      By Ed Michael
      My older LM 650 is blowing fuel into the air cleaner.  Any idea on what would cause this?  It is the Suzuki motor.  Not sure what model year it is.
      Thanks
      Subaru SxS.mp4
    • Jon Spruill
      2018 Hisun Sector 1000 Crew stalling but starts right back up. Please help!
      By Jon Spruill
      Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
    • Duane Baker
      Hisun 700 engine
      By Duane Baker
      I'm looking for an engine for my Hisun 700 SXS.
      I've found a LOT of scam sites, and need to find a legitimate business to purchase a used engine.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...