Dirt Racing Products Race Spindles
-
Similar Topics
-
By ita47
I currently have a 2011 Polaris 400 H.O. that has fewer than 300 hrs on it. My buddy bought it new and I bought it with around 100 hrs. I use it around the farm and to get between two properties that are about a mile apart. I am tired of dealing with the choke when its cold or even cool out. It starts fine and runs ok if your driving but until it gets completely warmed up if you pull up to a gate and get off to open it will die. And because of the choke my wife has a hard time with it. Before I got the 400 I had a 2013 polaris 500 midsize that was fuel injected but aways ran rich and foul plugs. I had it at two different dealers and neither one could fix it. So I sold it and bought the 400. My father in law has a 2015 Polaris 570 midsize which is fuel injected and it is hard to start and cranks more than it should. Needless to say I am done with Polaris and ready to sell mine and move on to something better.
I have been looking at the Honda Pioneer 700 and the Kawasaki Mule Pro MX. I was disappointed to learn the Kawasaki Mule Pro MX engine is built by Hysun and not Kawasaki, but that maybe a non issue. Maybe I'm missing another good option that I haven't considered. The main thing is getting something that is bullet proof reliable. Any feedback would be greatly appreciated.
Thanks in advance
-
By Hig
Just purchased a new Axis 700 which was delivered a few days ago. It's May 2023 and I received a 2021 model. Do they upgrade their model years like a car? The Axis 700 was brand new but the model year stunned me.
-
By J R
Hi, I just bought a used 2015 MSU500 with 365 hrs on it. After riding it the UTV seemed sluggish and would not climb a moderate hill without getting a running start in low range. Took it to a repair shop and they told me that the clutches were burnt and slipping. Had the primary clutch replaced and afterwards was told that the compression of the cylinder was only 80psi, which I was told was 100psi below original compression. I've bought all parts necessary, including new crankshaft and bearings to rebuild the motor. My question is, does anyone know if a 700cc top end kit will bolt onto the 500 motor case?
-
By Vanny
I purchased a Hisun 750 Sector to use for my oilfield business. It quit running after only 12 days. I was told by the very rude people at Hisun that apparently I wasn’t supposed to be driving it in the mud and that I also put to many miles on it.. so in-turn they will not fix it under warranty. Also, if the salesman tells you they are cheap to fix don’t believe it. They want half as much as what I paid for it to fix it. My advice is be aware that these UTV’s are made for minimal use and not backed by the dealership or the manufacturer. Also it was thrown in my face by the warranty manager that since it was used for business the warranty is shortened to 90 days. I’m not sure what the difference is since it’s not covered under warranty even after only 12 days.
-
By Randy d
Looking for info on this new utv I bought and it has 38 miles on it now but the problem is after 10 minutes of driving it bogs down and I have to full throttle it to get it going I can let off the throttle and slowly get it going without bogging to much but it still does and when I give it full throttle it smells like sulfur. I'm leaning towards catalytic converter but it's still new. Any thoughts.
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.