By Ridge Runner
Need advice on a fuel filter. This is a 2019 Coleman 550 Outfitter. Manual said to change fuel filter. Mine was assembled without a inline filter between the in tank fuel pump and the injector. I called Coleman, they told it was supposed to have a fuel filter. They sent me a metal inline filter and two clamps. The fuel line has what looks like an aluminum outer cover. I’m assuming the fuel line is a rubber one. Before cutting the line I looked at the metal fuel filter to see the direction of flow. Nothing marked on the filter. I called Coleman.…. They couldn’t help me, even after speaking to a Tech rep. It’s fuel injected, so I don’t want to screw this up. Does anyone have any ideas? Should I throw this filter away, and buy something else? I have replaced plenty of fuel filters on lawn mowers etc, but all were clear plastic, with directional arrows. Since this fuel injected, I’m thinking I must ypuse the special clamps, that require special pliers to tighten, and I might need a pressure capable filter?
By wes treleaven
Hi all, New member and new joyner trooper owner here.
Just picked it up yesterday. I worked for it. -40C here in Winnipeg, Canada loading it into a trailer. Unit was too tall. Some ratchet straps, recopricating saw and a lot of F^#ks.
Anyway she came with a broken front driveshaft. One of the ears was cracked off. I have a replacement but i am unsure how the driveshaft comes off the transfer case.
Doesn't sem to pull off or have any way to remove it. Any suggestions??
By erk mann
Bike was flooded in tropical storm. Replaced ecu and coil. Motor turns over but no spark have 12volts on one wire of coil. How much voltage should be on other small wire? Crank position sensor is about 200ohms. . Cleaned plug with sandpaper. Want a wiring diagram to check voltage at ecu. I have update. The blue wire going to coil has no voltage when turning it over. The white with black stripe has 12vdc when key is turned to on position.also, how do I clean the connectors on ecu? I dont see how I can get a screwdriver in there to release them. Found a schematic.i still need to clean connectors though
2009 Hisun HS700 UTV ---- I thought the problem was electrical but I just found this in the oil filler tube.By Rick McGill
I thought the problem was electrical but I just found this in the oil filler tube. Does anyone recognize the part? I know I'll have to tear down the whole engine, and maybe I'll find the rest of it in there. Something beg enough to seize up the engine. That was the problem I was trying to diagnose.... 'Cause it's locked up.
Thanks in advance.