-
Popular Now
-
-
Similar Topics
-
-
By T6 Texan b
2012 hisun hs800 problem with grinding when moving shifter into high and low gear.
has a shifter cable “not” a rod or link edge . Any thoughts on how to fix this issue?
-
By Robert301972
I just bought a 2012 can am commander xt Rotax 1000 4x4 EFI. It has 456 Hours on it and 6543 miles on it. From what I have read that is not a hole lot. It will start Right up run for about 5 or 10 sec then starts to stubble and then stalls. And ever time I start it It runs fine for the first 5 or 10 sec. I can Repeat the process for about 8 or 9 times and will will at least stay running. But it does not run fine until it is warmed up. Once it is up to operating temp it runs and drives fine. I have Replaced the fuel pump. Thinking that was the problem but no. I replace the map sensor It wouldn't even start with the new one in. So I put the old one back in and it started Right back up. I Think I had a bad map sensor. I will get a different one. It Is definitely a fuel problem. I just don't know what kind of problem. Here Is my thinking on all the sensors. (Crank sensor) all that does is send a single to the coils. That don't care if the motor is cold or warm. (Map sensor) all that does is measure the temp of the air.(Fuel Injectors) If they were bad it would not start at all. If they were clogged. It would run like shit if it was cold or warm. (Temp sensor) This is the only sensor that tells the computer weather the engine is cold or warm. So what is the temp sensor is telling the computer that the engine is warm. When I first start it. the computer will think that the engine is at operating temp. So It leans out the fuel mixture. So with a lean fuel mixture going into a cold engine. It Is going to stall. I have no scan tool to hook up to the computer. So Please help. I am at my wits End trying to figure this thing out.
-
By redneckred
After replacing a master cylinder on this machine, I was bleeding the brakes and discovered the brake line that connects to the rubber hose coming from the master cylinder under the seat and turns into a small tube going to the back brakes appears to be leaking at the joint. I checked the connections and found them to be tight. I was looking at getting a replacement part, but can only find parts for the front brake line hose to the calipers and not anything from the master cylinder back to the rear hoses. Does anyone know where to find this part or what the part number actually is? Not sure if I can fix the leak and I am not a brake hose rebuild guy, never had much luck without them leaking.
-
By Red Good
I have a massimo 500 with a blown motor and want rid of the rest of it . Is that ok here ? Motor is in a box , has low hours on the machine be a good parts machine for someone or stick a different motor in it . Tires are good body looks like no use on it . 500 bucks takes it away . 918-479-4200 located in NE Oklahoma . Red
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.