Quantcast
Jump to content

FX PRO EPS LE Side curtans


Bob K.

Recommended Posts

Hi All, New to the Forum but not new to Mules.
I am upgrading from Mule 610 to a FX PRO EPS LE. (2016 new old stock).
Added the Kawasaki full windshield, winch and plow. I really want to add the soft doors as shown in the attached picture, direct from Kawasaki accessory website.
Has anyone seen these doors installed on a PRO FX with the hard top?
The notes in the item description says they only work with the full windshield and the full soft enclosure.
The dealer agrees with me and believes they will work fine but isn't willing to commit. (take them back if there is a problem we can't see)


Any words of wisdom would be great.

Many thanks,

Bob

Sidecurtains.jpg

Link to comment
Share on other sites

Well I downloaded the install instructions for the doors and it is clear that the doors do not need the complete soft top to work on the FX PRO EPS LE.
The windshield does make a difference because of hinge mounting and the mounting of the windshield support brackets. I am rolling the dice and ordered the door along with the other options for my new Mule.
I will keep everyone posted on the outcome including pictures.

  • Like 1
Link to comment
Share on other sites

  • 2 weeks later...

Well the saga continues.
I appears the options I ordered are back ordered and not expected to be in until mid Sept. I decided to leave the machine with the dealer until all the options are in and installed. He was ok with that but it seems there is a factory rebate the runs out at the end of this month. Soooo, I have to go in and pay, "take delivery" before the end of the month or lose the rebate. I searched long and hard to find this machine so this dealer is a solid 2.5 hour drive to get to. I don't own a trailer big enough so I will have to rent one.. The end result of this situation is I will have to drive out to the dealer to pay and do paper work, and still leave the machine there. Then in Sept when everything comes in and gets installed I will rent the trailer and make the last trip to pick it up.

So for this thread there is likely going to be a long wait for the update that describes the results on the doors (side curtains).

Thanks to all for the input. I will continue to monitor this thread for any additional comments.

By the way, the dealer has been great through out this deal. I will be happy to pass along the name to anyone that asks. Dealer location is PA.


Bob

Link to comment
Share on other sites

Quick update.... I paid, did the paper work and left the unit at the dealer until the accessories come in and get installed. (according to plan) The dealer had a nice surprise for me... He gave me about $150.00 of official Kawasaki clothing and a hat. Really nice gesture. it is really a shame he is so far away..

I found another post where the soft top/back were installed with the hard top. The guy said it worked out great and they only had to make a few small holes in the soft top to reattach the hard top. Interesting.. as I have some time to think this through we will see.....


Keep the tires on the bottom...;~)

Bob

Link to comment
Share on other sites

  • 4 weeks later...

20180816_112440.thumb.jpg.d1dd4c159a909d780c7ca1661102b0ae.jpgOK.... All the parts are in and I took delivery of my new / old stock 2016 Mule Pro EPS LE 8/16/2018! Yaaaa. The unit is all put perfect. The dealer installed a brand new battery. ( nice touch) The winch, Plow Windshield and "Side curtains" all fit and function perfectly. A primary reason for this post is to inform the world the soft side curtains do not require the full soft enclosure. They function just fine with out it. Keep in mind they do not form a perfect seal and I fully expect they will leak a bit and will be drafty. I never expected the doors to close like a refrigerator. You will be able to sit out in a rain storm and stay reasonably dry. They will keep most of the blowing snow off you and for sure break the wind.
The unit rides better than my 2016 $60k Ford truck over the dirt roads.

Another piece of useful information. If you expect to rent a 6 X 12 utility trailer from UHaul for transporting you new or old Mule Pro don't! The opening in the rear where you would expect to drive your machine up the ramp and onto the trailer is too small!!!!
This info is not published on any of the UHaul specs that I could find. I was lucky and noticed it just as the tech was dropping the trailer on my hitch. I had to regroup and ended up renting a car hauler trailer for the 2.5 hour drive back from the dealer.
Also the car hauler trailer was more than twice the cost of the utility trailer.


The dealer is Sport & Turf in Pottstown PA. Worth the trip for sure. Sales person Chris. Really a very nice and knowledgeable guy.


Now I need to concentrate on logging some serious hours on the beast!

Keep the tires on the bottom,  ;~)

Bob


20180816_112451.thumb.jpg.543c3347745088733ddac53b997dcd18.jpg
 

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Alien10
      I have a Coleman Outfitter 550 purchased in January 2022 that runs and operates pretty well.  65 hours on it so far.   It is a work vehicle for my 10 hilly acres with two 1 acre woods and 5 acres of "lawn".  The rest is under a lake. 
      My parking brake does not seem to have any grip.  It worked when new but after a month or so, it is just almost useless.     I press the parking brake pedal hard until it stops. Still, it won't hold even on slight inclines.   I don't see the caliper move as I press the brake pedal down.  There seems to be plenty of pad left on it and the rotor is shiny as if it is rubbing a little when applied, but not enough to stop it from rolling. 
      Any thoughts on possible causes? 
       
    • By sister sweety
      Thank you for adding me, I am the owner of a 2021 axis 700 UTV and also a 2023 Can-Am defender UTV

    • By Buddee
      Put a new carb on the 500 to replace the leaking OE one.  Machine idles fine and mid and top end runs great.  It tends to have a hesitation right from the start - bottom end.   Thinking it may be the air/fuel screw??  I didn't do anything with the carb out of the box and is it direct replacement for my machine.  Of interest is the manual choke doesn't seem to work very good now.... wonder is it getting too much air?
       
      Any help appreciated!
       
       
    • By ATRican
      Just got a 2024 Odes Junglecross 800 cc four door 5 seater today. Feel free to share advice on longevity tips and common failures of this model.
      AR
    • By donny
      Hey everyone new to forum I have a 2014 Odes raider and a 2009 Suzuki Ozark 250 both down atm 😔
×
×
  • Create New...