Quantcast
Jump to content

Massimo 800


Sean Martin

Recommended Posts

  • 2 weeks later...
  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By joe1
      I have a 2019 550  Coleman side by side and it is starting to be hard to crank in the mornings but when it's warmed up it runs fine it's changed plugs filters for the inline gas filter in checkers temperature sensors map sensors and don't know what it could be any help would be appreciated
    • By Rufus Fruge
      Just wanted to check in and say hi to fellow members. I bought a 2023 T-Boss 550 last month just in time for hunting season. So far all is well. I went over it to check things out and learned a lot in the process.LOL! I certainly would recommend that all new purchasers should make it a point to do this because I can promise you that you won’t regret it.
    • By William Carberry
      I have a MSU 500. I will start and run but requires basically full throttle to move. Does this machine have a drive belt? If so how difficult to change?
    • By johnpeter
      2013 POLARIS RZR 800 LED LIGHTS On Ebay
      https://www.ebay.com/itm/276207679509?

    • Get More For Your Device
    • By matthejl
      Quick history:
      Bought it about a month ago and when I test drove it, it ran good. Loaded it up and took it home. Owner said it had been sitting for a long time, but was "just serviced". It only has 500 miles on it total. Drove it around and found out the charging system wasnt working...so had to charge the battery once every week and a half or so. One day my daughter was driving it and it died. I couldnt get it to start again and I noticed there was no fuel in the filter...I first checked pulse/vacuum line to make sure it was sucking and it was. So I replaced the fuel pump with one I found local...which is for a large riding lawn mower...and it worked. Engine started and ran, but struggled at low speed immediately following running it at higher speed. It would bog when decelerating. I have also noticed now that it will backfire some on decell and die.
       
      In the meantime, I went ahead and installed new stator and trigger coil assembly to get the charging system working again (that was an issue because it would not start at all after that...but eventually found that the trigger coil was wired backwards in the plug from the factory). I have also set valves, but I set them to .005 (intake) and .007 (exhaust)...per the manual. But what is weird is the manual states its mainly for the 700 series, but "can" be used on other models. On the front it says 500/600/700. I have noticed that the most common setting seems to be .005.
       
      Anyways it still has the issue to me that seems like its running lean. Not full power now, struggles immediately running it faster, and will die and pop some on deceleration.
       
      My main problem now is that it wont get to higher rpms as fast as it did when I first bought it. It struggles on deceleration after running near top speed.
       
      Things I have done:
      changed fuel pump
      replaced stator / pickup coil
      thoroughly cleaned carb (twice)
      set valves to .005 and .007 (is .007 too loose for exhaust?)
       
      anyways it seems to have a lean problem, and wondering if you have any suggestions on what to check.
       
      Thanks
  • Gallery Images

×
×
  • Create New...