Quantcast
Jump to content

Need advice on trooper supercharger install


Recommended Posts

Hi, I'm getting ready to supercharge my trooper and I'm looking for advice on the setup. So far I have... a AMR500 supercharger, small intercooler, Dolbeck EJK fuel controller and wideband. Looking for any advice on what else I'm going to need and what to expect..Thank you

 

 

 

Link to comment
Share on other sites

Thanks! This is exactly the type of thing I'm looking for advice on! Do you know the specs of the one I'll need?  Would it be a 5v 1w? Also from the 1100 service wiring diagram it showed 1 is pressure signal 3 is temperature signal and 4 is ground.. And  the first diagram shows the diode between signal and ground. So I'm guessing the diode  goes between 1&4 and not 1&3 like you Drew on the paper...?

  • Like 1
Link to comment
Share on other sites

Thanks! This is exactly the type of thing I'm looking for advice on! Do you know the specs of the one I'll need?  Would it be a 5v 1w? Also from the 1100 service wiring diagram it showed 1 is pressure signal 3 is temperature signal and 4 is ground.. And  the first diagram shows the diode between signal and ground. So I'm guessing the diode  goes between 1&4 and not 1&3 like you Drew on the paper...?
Yes been so long ,5v 1w works ,think your right 1-4 , I also got a field controller from dobeck but I had them max out to 12millisec or the longest pulse available " been couple years hard to remember "
Running a gt15 turbo seems to work fine

Sent from my SM-G930W8 using Tapatalk

  • Like 1
Link to comment
Share on other sites

Ok cool! Seems I'll be basically replicating something similar to your setup just supercharger instead of Turbo, until I can go megasquirt later like Lenny(hopefullywhen i have more money)!... So if you could run down everything you had to make it work, I'd appreciate it..  Did your dobeck have a  vac/boost line.. Because I've seen ones with it and I have the one without it... Also did you have to go water/meth injection or 100 octane anything like that.. Thanks..

Link to comment
Share on other sites

Ok cool! Seems I'll be basically replicating something similar to your setup just supercharger instead of Turbo, until I can go megasquirt later like Lenny(hopefullywhen i have more money)!... So if you could run down everything you had to make it work, I'd appreciate it..  Did your dobeck have a  vac/boost line.. Because I've seen ones with it and I have the one without it... Also did you have to go water/meth injection or 100 octane anything like that.. Thanks..
Forgot went to ejk after 1st programmer broke
Used these setting for basic setupd1906ade94a28b10a5e1a476db2723b0.jpg

Sent from my SM-G930W8 using Tapatalk

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Steve B
      My "R" light on the dash will not go out when I take the UTV out of reverse and put it into any other gear. Is this just the light switch issue or will this effect engine performance in the other gears?
    • By Nathon S.
      I have a Bennche 700 EFI Bighorn. I’ve recently been unable to get it to start. After a little troubleshooting I realized my fuel pump was not pumping fuel. This weekend I emptied the gas and replaced it with new. I replaced the fuel pump, fuel filter and fuel injector. I also replaced the battery, spark plug and made sure all my fuses and relays were good. I have confirmed that the float on the fuel pump is not obstructed. The UTV is about 12 years old and has less than 100 hours on it. It has not run in over a year.  Not sure whats going on?!? After doing a little reading I'm leaning towards it being an issue with the ECU or perhaps a faulty wire in the wiring harness. Anyone have any ideas on where to start looking or what I could be dealing with? Any help is appreciated, thanks in advance!
    • By REDfletching
      Spent today at a Honda dealership looking at their 520 side by side, then on the way home past our Lowes noticed they had several new UTVs on site, so we U-turned and ducked in there. We were impressed that all that came for $9,999 metal whole length skid plate, nice sized bed, roof, windshield, side mirrors, winch, upgrade looking tires… all of which would have added thousands of dollars to an already expensive Honda 520. Now Honda does have a great reputation from my trusted UTV experienced buddy, so it has that going for it.
    • By Hi sun 500
      hello everyone, i just joined this forum to try my luck, few days ago i bought an old (dont know exactly), 2011/14 hi sun 500cc ""carburated"",  was not running at the time, but i fell was a good deal and decided it to bring it home to play with it, this is the issue, i bought and installed a new carb, and pump, i repositioned the battery location and upgraded to a "car batt", reconnected the fuel lines and started it, but it only runs with the choke ON, i checked the bowl, it does have fuel,but for some reason wont inject it to run, i came across a video that say that ""the body small tank had to be connected for the cart to run" (was deleted when bought), sure enough i got it to run sporadically , but the so called ""small body tank'' often runs out of fuel and wont refill itself , i had to couple times do it manually, so how does that small tank works ?..what does it do?..and why if  bypass it , the cart wont start?....any help?..thanks so much!!!
    • By MJG
      Hello, 
      I found an 08 Renegade for sale and looking to purchase it.  I haven’t heard too much about these machines and any insight would be much appreciated.  Are they good machines?
×
×
  • Create New...