Quantcast
Jump to content


Recommended Posts

Posted

I have a 2015 Kawasaki mule 4010 4x4 that wont run more that 5 seconds when the engine is cold and the o2 sensor is plugged in. once I disconnect the sensor it runs and has lots of white smoke out of the exhaust. once it warms up I can plug the o2 sensor in and it will run fine. I swapped the sensor and didn't get any change.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • By BigWave
      I turned off the key and then tried to start it a minute later and it would not start. I changed out the fuel filter and the injector. still nothing. if i have the injector pulled out and close to the hole the injector will spray fuel into the hole and it will run but the minute you put the injector in it will die. any idea's please
       
       
      Bigwave
       
    • By Kevin Ullman
      View File 2015 Polaris RZR900 Service Manual
      2015 Polaris RZR900 Service Manual
      Submitter Kevin Ullman Submitted 04/23/2025 Category Polaris  
    • By Mike Jenkins
      I have a 2013 Hisun with a 686 Yamaha engine.
      I purchased it from an individual and it ran fine as long as the battery was full.
      I replaced the stator and now it will not start (run).  It cranks fine, has fuel pressure, but will not fire up.  I replaced the coil, no luck there.
      a technician told me that it was the wrong stator and wants a mint to replace it.
      the wires all plugged in when I installed the stator.
       
    • By Duane Baker
      I'm looking for an engine for my Hisun 700 SXS.
      I've found a LOT of scam sites, and need to find a legitimate business to purchase a used engine.
×
×
  • Create New...