Quantcast
Jump to content


Magnum Tuning chip - worth it?

NC4wd

By NC4wd
in AXIS Off-Road UTV SxS Forum

 Share

Recommended Posts

  • 3 weeks later...
Greg Kilgore Community Regular

Greg Kilgore

Posted
Posted

I've seen those advertise on the net. Seen a guy on YT that installed one. He said they work. But like you, I would like to hear from others before I installed.  They are kinda expensive. 

There's a writeup here on how to get into the ECU to read codes and get the engine parameters (parts and software required). From my understanding the ECU also has flash memory that some parameters can be changed and saved. I haven't tried it. If you do let us all know how it goes. Good luck.

 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing


  • Popular Now

  • Similar Topics

    • mike28honda
      Axis 500 cuts out at about half throttle
      By mike28honda
      I have an Axis 500 and never had any problems until now,it cuts out 
      at around half throttle. I changed the TPS with no difference, acts like the seatbelts aren't set but can get up to around 15 mph as long as I don't give it too much gas, thanks for any advice 
    • Nick Varnes
      Bennche bighorn 500 idle issue
      By Nick Varnes
      So I have a Bennche Bighorn 500 that I bought used a couple years ago. Was working fine until this winter when I was plowing and I think it drained the battery. And had a difficult time starting and staying running. Idle seamed really low, and would only stay running if I pushed on the throttle. So I changed the battery, and the acm valve, fuel filter and spark plug it will start up and surgery to 3k rpm but comes back down and dies, unless I give it throttle. I am getting fairly good amount of fuel from fuel pump.  It does spit at stutter right before it dies. What should I try next?
    • Firewalker918
      Anyone customized their uv34XL? Also, looking for seatcovers
      By Firewalker918
      I have a 2021 UV34XL and I am kind of looking to change it up from the orange wheels and maybe do a wrap?  Please share photos of any XLs that has been modified to look better and any seat covers recommended.thanks
       
    • Hoppy one
      Bennche 500, replaced stator no fire
      By Hoppy one
      I replaced the stator on our Bennche 500 because it was not charging. It ran as long as you kept the battery charged. I replaced the stator now it’s not firing. The only problem I found was a wire in the new stator for the crank position sensor was in the wrong place in the plug. I switched it around but still no fire. Putting a meter on those wires and cranking the motor showed no voltage from the crank position sensor. Something I did or a bad “new “ part? Thanks for any ideas.
    • JohnnyB
      Massimo 500 will not start
      By JohnnyB
      My Massimo 500 will not start. I’ve checked all the obvious things. It turns over just fine. fuel, spark, fuse box are all good. I can’t figure it out. Any ideas would be greatly appreciated. Thank you.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...