Quantcast
Jump to content

2012 Hisun Strike 800 UTV No Start

Joe in CO

By Joe in CO
in Hisun UTV SxS Forum

 Share

Recommended Posts

Joe in CO Newbie

Joe in CO

Posted
Posted

Hello everyone.  I picked up a 2012 hisun strike 800 UTV.  Previous owner said that it overheated.  They were trying to drive it back to their vehicle and said it just stopped running.  He said he thought it was a blown head gasket.  They replaced fuel pump and looks like a new starter solenoid relay.   It does not have any antifreeze in the oil so don’t think its head gasket (I ordered new ones anyway). It turns over but not with a lot of juice.  (Kind of like an almost dead battery). I put in a new battery but still does the same thing.  Any thoughts?

Link to comment
Share on other sites
  • Alex changed the title to 2012 Hisun Strike 800 UTV No Start
  • 3 weeks later...
Dan B Community Regular

Dan B

Posted
Posted

I would do a compression check just to ease my mind.  The spark plug(s) can tell you about the conditon of the cylinders, too.  How does the engine turn over with the starter and with the plugs removed?  You could still have a blown head gasket.  There are three combinations:  Cylinder to coolant jacket, cylinder to oil passages, oil passage to coolant jacket.  Overheating can cause the head to warp just enough to blow the head gasket or distort the cylinder walls or cause the rings to seize up.  A weal starter can be the issue with slow turning of the engine (experienced that with my riding mower).

Link to comment
Share on other sites
  • 7 months later...
Arthur 1970 Newbie

Arthur 1970

Posted
Posted

I just bought a coleman 800 hisun motor. I am having a problem with over heat light comes on but my radiator is still cold so fans don't turn on. Is there another heat relay somewhere on engine. It is getting warm but not coolant to radiator? water in radiator is still cold? Does it need new water pump or do you think it has a bubble lock somewhere?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • buckrub
      trying to finish assembly "new" 2021 Coleman ut 400
      By buckrub
      Hey guys! Newbie here. I'm an old man who's better with plowing a mule (4-legged kind) than these newfangled beasts. I, and a friend of mine, just bought new Coleman sxs and are having to finish the assembly. I've been reading on this site and I'm falling on the mercy of you experts. The only way I'm an expert is that an "ex" is a has been, and a spurt is a drip under pressure. LOL First off, the 2 buggies have no ignition switches. They seem to mount on the dash, not the opening in the steering wheel shaft cover, so we ordered new ones that are supposed to fit. They are 8 inches long, and have a 4-wired white plugin which is slightly rectangled when looking at the end of the plug. The trouble is there's nothing to plug into. There is a three-wire grey plug close enough to reach the four-wire plug, but of course, they are not compatible. 
      Secondly, the blinker, light, ect. unit on steering wheel just spins around when touched. I see no way in heaven or earth to secure it. I've looked at a diagram on the Powersports site, but can't detect how it mounted. Fellows I'd be so grateful for any help with this. Me and my mule will even plow your garden for free, for your help. LOL 
       
    • hdtran
      Hello from New Mexico!
      By hdtran
      Hy (pronounce he), just bought a Hisun Sector E1.
      I'll be using it to haul logs and stuff in the Sangre de Cristo mountains.
    • ETHIEL
      2012 Coleman 500 UT plug keeps fouling.
      By ETHIEL
      Spark plug keeps fouling. after 10-15 minutes of running any ideas what to look fore 
    • Hugh
      2018 Hisun Sector Crew 1000 engine die after about 15 minutes run
      By Hugh
      My 2018 Hisun sector crew engine cut off after about 15 minutes run. There is no indicator of what is wrong, no error code just die and won't restart until it cool down. I notice that the fan is not running but the temp indicator is on low temp, no overheat indicator. I checked the radiator fluid, it is cool to touch.
      Cooling fans are working, I can hear it running once awhile if I can get the engine warm up enough.  Thank you for all the help.
       
      Hugh
    • Hi sun 500
      2011/14 Hisun 500 fuel issue
      By Hi sun 500
      hello everyone, i just joined this forum to try my luck, few days ago i bought an old (dont know exactly), 2011/14 hi sun 500cc ""carburated"",  was not running at the time, but i fell was a good deal and decided it to bring it home to play with it, this is the issue, i bought and installed a new carb, and pump, i repositioned the battery location and upgraded to a "car batt", reconnected the fuel lines and started it, but it only runs with the choke ON, i checked the bowl, it does have fuel,but for some reason wont inject it to run, i came across a video that say that ""the body small tank had to be connected for the cart to run" (was deleted when bought), sure enough i got it to run sporadically , but the so called ""small body tank'' often runs out of fuel and wont refill itself , i had to couple times do it manually, so how does that small tank works ?..what does it do?..and why if  bypass it , the cart wont start?....any help?..thanks so much!!!

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...