Quantcast
Jump to content

Winter is finally here in Texas... for a little while

Travis

By Travis
in General Discussion - Anything

 Share

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Robert B
      2021 UTV 400 going downhill something releases to "Neutral" loud Clacking noise.
      By Robert B
      Going down a 20 deg hill engine is holding UTV back. Then something releases like going into Neutral and makes a loud clacking noise. Have to use brake to slow UTV down. Then once level it shifts back into gear. Have done shift extension does not pop out of gear.
    • azdesertdog
      Looked Like Lord of the Rings
      By azdesertdog
      A desert camp trip we took at Christmas in the desert
       
    • JFC
      Snow Plow on 2015 Kawasaki Teryx 800LE
      By JFC
      Want to add a Snow Plow.  Vehicle has been lifted 2".  Does the bracket need to accommodate that extra lift to keep the plowing geometry correct? Denali, Switchblade, KPI, Poly v Steel?  Any recommendations. 
    • Kenbaz
      Hello, New Guy Here
      By Kenbaz
      Hi Folks - Have owned a Coleman UT400 for two and a half years and use it daily for horse chores. It's been a good unit,  just had to change sparkplugs frequently in the cold weather. Just the other day we ran it out of gas and have been unable to start since. Have posted for help on the Coleman portion of this board. Thanks in advance!
    • Greg Kilgore
      Cooling fan. Not just for radiators.
      By Greg Kilgore
      We all know summer is hot inside the cabs of our SXS. So I've rigged up a couple of fans to help cool down the cab.
       
      I didn't want to drill the fan's "support rails" into the ROPS (Roll Over Protection System), aka roll bars. So I used water clamps to hold them in place. 
       
      I just need to replace the wires I ran with bigger gauge. Then finish the wiring to switches, relays, and battery. But the hardest part. The actual mounting of the fans is complete. Also just in case anyone plans on doing this. I may have to only use 1 fan in the middle instead on 2. Due the the draw on the battery.
      The fans are 12", 12V 80W. So I'm figured they were 6.7 amps apiece. Used the WAVe formula to get unknown values Watts=Amps*Volts then solve for unknown. I know the watts and volts from sticker on fan. So just used above formula to get amps. So a 7 amp fuse should be OK and a 10 amp fuse will be good. 
      So pulling 14 amps from the battery all day may be too much for the charging system to keep up with. And I haven't even installed the radio yet. So I will have to test and let you know.
       
      See pics below.

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...