-
Similar Topics
-
By joe1
I have a 2019 550 Coleman side by side and it is starting to be hard to crank in the mornings but when it's warmed up it runs fine it's changed plugs filters for the inline gas filter in checkers temperature sensors map sensors and don't know what it could be any help would be appreciated
-
By Tim Barbero
I left my 2020 axis 500 UTV parked under the carport for about 6 months and when I went to start it recently a squirrel has built a nest under the throttle body and chewed through the efi harness. I stripped all the wires back and reconnected them with waterproof butt connectors. The problem I have is there is one blue wire with a red stripe coming from the main harness this wire has 5 volts dc showing on my multimeter but there are two blue wires with a red stripe coming from 2 different sensors on the throttle body. I looked through all of the bits and pieces of wiring left behind and there’s no indication that the three wires of the same color were all tied together. Any help with this issue would be greatly appreciated.
-
By lozomex
After a few days of heavy rainfall I got in my Sidekick and noticed that the belt seemed to be slipping as I was making my way out on a large property. I turned around and could barely make it back to my shop. After removing the cowelling I noticed about a quart of water drained out. I dried the area, the cover and checked the belt. No signs of dammage, belt looks great and no foreign debris other than water in the area. I put it back together and there was a definite improvement. The Sidekick is driveable now but the belt still slips but only at a higher speed and only when the throttle is punched. I'm wondering whether I may have inadvertently damaged it while it was wet and have ordered a new belt. I have looked on line to see if there is a guide or procedure, specifically for the CVT belt removal and replacement for the 850 but can find none. Does anyone have experience with this?
-
By Horace79
I have been searching the Internet for the past week looking for UTV tires and I'm stuck. I don't want mud tire that are 30+ inches in diameter witch is all I have been finding. My rims are 20"x7," so my question is can I order a set of 235/30R20 car tires and will they seat on these UTV rims. Thanks to anyone for help or advice.
-
By Bob Marshall
I know this topic has come up many times before but I see nothing that duplicates my issue. I replaced the wet clutch and after reinstalling the primary things changed. i had to realign the weights in the clutch because they came out of the slot. Now I have a knocking in the clutch that I cant find the source . I know the one way bearing is correct - spins clockwise and turns the crank if turned CCW. I have included the YT link. The primary is engage enough at idle that I cant put in gear while its running. Idling @ 1300 rpm. Tried new belt and old belt with no improvement. I am not sure the primary should be turning at idle which points to the wet clutch? I started the engin with the primary off and no knocking occurred
-
-
-
Gallery Images
.jpg.20223437086d05b33428002722c88a8d.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.