Mule 610 incline power loss
-
Similar Topics
-
By great8redsfan
Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power. They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil. Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm.
-
By LongSun
I can not find it on the board, so I'm afraid I'm the only cheapo on the forum.
What is the fuel economy of the Hisun HS590? (I guess it is the same as the HS550)
I count in liter per 100 km, but if you use MPG it's okay with me, but please tell if you use the US or UK MPG!
-
By Buddee
Put a new carb on the 500 to replace the leaking OE one. Machine idles fine and mid and top end runs great. It tends to have a hesitation right from the start - bottom end. Thinking it may be the air/fuel screw?? I didn't do anything with the carb out of the box and is it direct replacement for my machine. Of interest is the manual choke doesn't seem to work very good now.... wonder is it getting too much air?
Any help appreciated!
-
By Nathon S.
I have a Bennche 700 EFI Bighorn. I’ve recently been unable to get it to start. After a little troubleshooting I realized my fuel pump was not pumping fuel. This weekend I emptied the gas and replaced it with new. I replaced the fuel pump, fuel filter and fuel injector. I also replaced the battery, spark plug and made sure all my fuses and relays were good. I have confirmed that the float on the fuel pump is not obstructed. The UTV is about 12 years old and has less than 100 hours on it. It has not run in over a year. Not sure whats going on?!? After doing a little reading I'm leaning towards it being an issue with the ECU or perhaps a faulty wire in the wiring harness. Anyone have any ideas on where to start looking or what I could be dealing with? Any help is appreciated, thanks in advance!
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.