josephb

I'm looking for a 4 wire ignition cylinder switch assy with key for a 2006 Joyner 800 Renegade. I don"t have a part number.

Looking to install 2 inch wheel spacers to a 2023 Can Am Defender. Bolt pattern is 4/137. Who makes the strongest set as I"m pushing the gvw limit and want more stability? Thanks in advance.

I've had to remove and replace a couple axles in the past. Now I just can't remember how I did it. Yes, the spindle and hub is removed. Any trick to help would be greatly appreciated. T I A.

Bought mooseracing ball joints from Pratville powersports . Part #0430-0664 because they said they would fit. Guess what, negative. I installed all 4 without putting the spindles back on over the B J studs. (archery season here in Pa.) The ball joints fit perfect in the a-arms, but the next day when I tried finishing the job is when I noticed the diameter of the stud on these parts are bigger than factory. Ordered factory joints from Joyner USA. Guess I"ll be dragging a bid ol buck this year. Not happy, but I should have done a better job comparing the new against the old.

Thanks Dan. Got them today . Moose raceing. Will install hopefully soon.

Couldn't find in parts and pieces any aftermarket front lower ball joints for an 09 Renegade. Thanks in advance if you can help.

My 09 renegade steering is shot. Any reasonable upgrades been done?

Blown fuse. Rear of pass seat fuse block, lowest fuse.

My 08 renegade overheated yesterday. The cooling fan wasn"t running. I was able to hot wire the fan direct, and it worked. My question is, where are the cooling fan switch and relay located? Any help will be appreciated..

Just called JMC. The recording states that they are "relocating" and will be open Roctober 1. That's all I have.

If anybody has info for a napa or auto zone cap number for a 07 250 sand viper, please share it. Thank you in advance.

On mine [which is at my cabin]. Tank to filter, filter to fuel pump, fp to carb.

Correct.

And the winner is, napa posi-flo #610-1050.

Went to tru value store here in Pa. ilco blank # x105 Ka11. I believe it may be a Kawasaki blank. Anyway it worked.

I"ve looked through a bunch of old threads on fuel pumps, but wasn"t able to find an aftermarket fuel pump number. Anybody out there with one? Thanks.

Does anybody know what I can use for a key blank? 06 commando.

Thanks for the info, but where did you find it?

Has anyone ever tested alternator outputs at alt or at battery. Trooper uses same alt as renegade.Mine was 11.41 with idiot lite on, new one is 11.71 but no lite. I think this is too low. Thankd in advance for any info.

I"m hoping someone may have picked some of these up at the liquidation sale. Help please

Less than 70 miles on this 09. This has NNNNOOOO low end power, absolutly nnnnoooo throttle responce. Starts fine, runs fair if your 90 years old. Just no tjrottle responce, get the hint. I found the Vap canister upside down next to fuel tank, didn"t seem like there was any fuel in the lines, so i ran it 25 or 30 miles hopeing problem would just go away. No such luck. I checked fuel pressure,60, yes 60psi. Icut it back to 30 and now it seems like I can here it laboring. I also played with the TPS. no help. By the way, when i cut the fuel pressure down, it now hesitates and misses when you get right on the pedal. I have to go now. If anyone has seen this and can help,THANK YOU for your reply in advance.I have driven a couple Renegades before which really impressed me( could use a granny gear however). Thanks again, I would love to ride tis holiday weekend.

Need a clutch cable for an 07 C-2 commando. It should measure just shy of 7 feet. If you have one, please let me know. Thanks.

I have 3- 2008 T-2"s in stock that are left-overs. I"m in Pennsylvania.If ya want to talk, reply with a phone # or an e-mail address.

Need to replace stock (loud) muffler with a quiet muffler now that hunting season is here. Any aftermarket bolt ons around? Thanks in advance for any help.