Quantcast
Jump to content


Hisun 2009 "clunk"

Geof Rohrlach

By Geof Rohrlach
in Hisun UTV SxS Forum

 Share

Recommended Posts

Geof Rohrlach Newbie

Geof Rohrlach

Posted
Posted

love the forum. We just got a mostly rebuilt Hisun 2009, runs great, no electrical issues yet, however notice a grind and clunk after accelerating and stopping, such as at a stop sign. Sounds like wire caught underneath. We looked it over and only thing that comes close to being in the area is the secondary clutch. Some wear and play noted there. Will replace, but not sure if we are going to fix the problem.

  • 3 weeks later...
aefron88 Community Regular

aefron88

Posted
Posted

Interesting. the shift shaft and driveshaft are under where the secondary is also. I wonder if the shifter adjustment is off, and its popping slightly out of gear, and then popping back in? I'm thinking maybe the grind is it slightly out of gear, and the clunk is it popping into gear under load.

Not sure which model exactly you're talking about? Is it the console shifter or a dash mounter shifter?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Rschrem
      2010 700 Hisun starter issue
      By Rschrem
      Hi, my 2010 Hisun will crannk but comes to a stop and only clicks.  It has new battery and solinoid. Battery connections all seem good. Any ideas what the problem is? 
    • monkthumper
      2020 Hisun Sector 750 no pwr to fuel pump
      By monkthumper
      Fuel pump is good (i hotwired it) swapped relay with known good one no help. I'm leanin towards ECU but cannot find wiring diagram online. Dont know how fuel pump relay gets its signal, all fuses good, any help? 
    • Flanman55
      Wiring issues
      By Flanman55
      I have purchased a used Supermach700 (2008), It runs great after a new choke cable but. The temp sensor on the thermostat house is unhooked and can not find where it plugs back in. The fan has been un hooked from the sensor in the rad and cant figure out how it goes back together properly.  The fan was wired to a by pass switch and i just always leave it on but would like to work it properly. I assume the sensor went bad and not changed.
       
      any help would be great.
       
      thanks
    • BigWave
      2019 hisun won't run
      By BigWave
      I turned off the key and then tried to start it a minute later and it would not start. I changed out the fuel filter and the injector. still nothing. if i have the injector pulled out and close to the hole the injector will spray fuel into the hole and it will run but the minute you put the injector in it will die. any idea's please
       
       
      Bigwave
       
    • davebuckholts
      2009/10 American Sportworks LSV 48v
      By davebuckholts
      I just picked this UTV up off of Marketplace. It needs batteries. 
      I am installing a single 48v lithium battery. 
      The on board charger, a NOCO Genius GX 4820, has a lithium mode. 
      Has anyone here used this charger on new lithium batteries? I want to be certain of the compatibility before hooking the charger to this expensive battery. **
       
      **
      I got in touch with NOCO and they told me the charger is fine to use on a new LiFePo battery. 
      Nice charger. Many modes. New ones are running about $550. 

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...