-
Similar Topics
-
By Working hard to hardly work
Hey guys im in the process of rebuilding my massimo 500, and like a dummy I did not mark the cam. Im having a harder time finding timing info than i thought. Can anyone give me a no bs way to where and how i need to align the crank and cams to time this thing? Im still trying to learn how to properly time motors so any dumming down would be appreciated.
-
By Heidi Wilmoth
You will quickly see that I am new to this and don't quite know how to pose this question. I gave myself a Coleman 400 UTV for my 65th birthday a month ago."To Yaya: From Yaya" I've noticed a couple issues. First, as I drive around our acreage, sometimes it just putters, almost sounds like it's going to turn off. The other issue is the lights on the dashboard that correspond with forward, neutral and reverse don't match up to the actual gear. Sometimes it does but most of the time it doesn't. What I mean is that when I put it in forward to drive, the reverse light will be on the dashboard light. Sometimes it will be the forward light. When I put it in Neutral, sometimes the light on the dashboard /N lights up and sometimes it doesn't. Lastly the gas gauge does not register. Although the tank is almost full, it shows E / Empty.
-
By BeachBuggy
Massimo Buck 250 less than a year old. 900 miles on it. Live on beach in TX...i.e. corrosive salt air and normally mild temps.
The story - one day, it randomly quit on idle and was tough to restart. Next day, it occasionally cut out for 1-2 seconds while driving, then catch back to normal throttle. Pumped gas pedal, not sure if that helped it catch. Added some marine sta-bil and filled tank. Ran well after that for a day. Following day, wouldn't start. Turns over, cranks, but won't start. When it quit on idle that was the first time driven since we did have a freeze of ~25 degrees.
Full charge on battery. No spark. Changed plug and still no spark. Fuses look good, but fuse connection box has some loose clasps and spade were corroded. I bent clasps best I could and used dielectric on spades re-inserted. Cleaned and checked every connection I could find. Don't have a card reader to hook up, but did swapped ECU just to check that, and no change...after swapping ECU the engine light now stays on. Previously blinked and then goes away.
Under warranty but service place is 2 hrs away.
thanks!
-
By Jon Spruill
Hey Guys, I have been chasing a stalling condition for about two weeks now. The bike will crank up and idle fine, then after about 20 seconds it will fall on its face and stall. It happens at both idle and while running at various rpms. You can turn the key off, turn it back on and it will fire right back up without trouble. I have verified spark on both cylinders with a spark tester. I have also added an inline fuel filter, and pulled the injectors to verify proper pulse on each. Things I have replaced - (relearn procedure performed after each component replaced): spark plugs, ECU, relay/fuse box, fuel pump, & throttle position sensor - all with no improvement of the condition. The only warning light I get when the condition occurs is the oil lamp. The bike only has 14 miles. I am at a loss and appreciate any help and suggestions! Thanks
-
By Roadstar515
Just wondering if mine is the only one that’s seems very loud while driving. It just seems louder that other brands I’m use to. I guess you get what you pay for I’m assuming.
Regards, Rick
-
-
-
Gallery Images
.jpg.7db75608d6304a0b1453655b7c0267cd.jpg)
![ry%3D400[2]](https://www.utvboard.com/uploads/gallery/album_29/sml_gallery_475_29_6335.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.