Quantcast
Jump to content


2008 hisun 500 utv starter spins but wont turn the motor over

Hisun .500

By Hisun .500
in Hisun UTV SxS Forum

 Share

Recommended Posts

Hisun .500 Apprentice

Hisun .500

Posted
Posted

so this thing is a real turd i have gone through so much im ready  to junk it and live a few extra years but  one last chance  it use to run but now it just sucks money  i replaced the starter clutch and it still is doing the same thing just spinning does anyone think it might be the starter is ti weak to turn it over 

  • Hisun .500 changed the title to 2008 hisun 500 utv starter spins but wont turn the motor over
farmer99 Newbie

farmer99

Posted
Posted
On 5/10/2023 at 10:19 AM, Hisun .500 said:

so this thing is a real turd i have gone through so much im ready  to junk it and live a few extra years but  one last chance  it use to run but now it just sucks money  i replaced the starter clutch and it still is doing the same thing just spinning does anyone think it might be the starter is ti weak to turn it over 

You sheared the key on the crank you have to open up the side of the motor on the passenger side there'd be a fan then another cover with the magneto then the key way will be right there on the starter gear! It's a metric woodrife key! Best bet is to buy it on Amazon! 

  • 2 weeks later...
Hisun .500 Apprentice

Hisun .500

Posted
  • Author
Posted
On 5/12/2023 at 7:15 PM, farmer99 said:

You sheared the key on the crank you have to open up the side of the motor on the passenger side there'd be a fan then another cover with the magneto then the key way will be right there on the starter gear! It's a metric woodrife key! Best bet is to buy it on Amazon! 

Checked that so it was the starter clutch

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Popular Now

  • Similar Topics

    • rdc
      Looking for a left rear shaft carrier (just the carrier) for a 2007 Joyner 1100 sand viper
      By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • esmarkey
      2018 cub cadet 750 challenger clutch issues?
      By esmarkey
      Hi, I purchased a used Cub Cadet 750 Challenger that seemed like the belt was slipping so I put a new belt in.  It still acts like the belt is slipping but now I am thinking it is the clutch? 
      What is the best way to remedy this problem? 
      Can the clutch be rebuilt?
      Are there aftermarket clutches available? 
    • Garjess
      RTV 1140 Starter Relay
      By Garjess
      My rtv 1140 won't turn over.  I've jumped the neutral switch, and the brake switch, and checked the ignition switch. I'm not getting any power to the trigger wire on the starter solenoid.  It starts fine with the key on and putting power to the trigger wire on the solonoid.
      Does a 2010 RTV 1140 cpx have a starter relay? 
      Does anyone have a wiring diagram?
    • AaronD1982
      Massimo 400S Buck UTV Starter solenoid replacement
      By AaronD1982
      I recently purchased a 2019 or 2020 (no manual) Massimo 400S Buck Series UTV.  It ran fine for a couple days but the low battery light was flashing while it drove.  It then died in the field one day and I was able to jump the battery and get it rolling enough to get back to the barn.  It started both times I turned the key for a couple days after and when driven died 10 minutes later in the driveway.  Even after jumping it had no juice, but with the key out of the ignition it kept trying to start, a quick look on the Google machine and it suggested starter solenoid or ignition switch was the culprit.  Fair enough, let's just order a replacement solenoid, right?  No way Jose....the pin connector on the UTV is a 2-pin white plastic connector and the part received is a 4 pin.  How do I swap that and make it work?  Can I even?  Where do I find correct parts in the future?
    • MilSurpYinzer
      Must have upgrades/spares?
      By MilSurpYinzer
      Hey all, I was just wondering what you guys consider a necessary upgrade or spare part to have or mod onto your machine.
      I'm going for a kind of shtf survival rig that's not going to be SUPER heavy and I'm looking at getting:
      A spare belt (I keep seeing this mentioned everywhere I look so it must be important)
      A spare tire and mount( So would I need a jack like one from an old jeep or something else?)
      Tire chains for the winter
      And maybe a cargo bed upgrade so things don't slide out.
      Bumpers because duh.
      I already installed high output lights and have a windshield, roof, back window, and winch. And I outfitted a Molle panel for the back of my passenger seat with extra supplies like food, first aid, and spare mags.
      Any advise on increasing durability, longevity, and having something on hand because it's absolutely necessary would be a plus.
      Thanks so much!

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...