TROOPER Ball Joints & Tie Rod Ends
-
Similar Topics
-
By CYJSP2009
Dear Friends
Supply Hisun cables and Hisun parts.
We have Hisun cables stock in South Carolina.
Please send email to [email protected] for inquirying and further discussion.
Thanks
Casey/ Leaf Asia
2023-09-15
-
By CYJSP2009
Hi Friends,
Some of the original Joyner brake parts are available.
Interested parties please contact [email protected]
-
By Greg Kilgore
We all know summer is hot inside the cabs of our SXS. So I've rigged up a couple of fans to help cool down the cab.
I didn't want to drill the fan's "support rails" into the ROPS (Roll Over Protection System), aka roll bars. So I used water clamps to hold them in place.
I just need to replace the wires I ran with bigger gauge. Then finish the wiring to switches, relays, and battery. But the hardest part. The actual mounting of the fans is complete. Also just in case anyone plans on doing this. I may have to only use 1 fan in the middle instead on 2. Due the the draw on the battery.
The fans are 12", 12V 80W. So I'm figured they were 6.7 amps apiece. Used the WAVe formula to get unknown values Watts=Amps*Volts then solve for unknown. I know the watts and volts from sticker on fan. So just used above formula to get amps. So a 7 amp fuse should be OK and a 10 amp fuse will be good.
So pulling 14 amps from the battery all day may be too much for the charging system to keep up with. And I haven't even installed the radio yet. So I will have to test and let you know.
See pics below.
-
By Spencer Marks
Hello all,
I just finished replacing my front and rear drive shafts. I drained and put new dif fluid in the rear dif. I went to the local dealer and they told me the fill capacity of the front and the transmission as I want to replcae that as well but they could not tell me how to access the fill. One how do I access the fill for front dif and 2 is the transmission fill the same as the rear dif? I don't see a dip stick or fill for the transmission but all in same area.
Also, anyone can suggest a good shop/service manual for this bike?
Thanks
Spencer
-
By johnney
i have a 2011 ys 400 and when i lock in the 4x4 right front axle doesn't lock in , actually grinds a little but doesn't lock in...
HELP FROM MINNESOTA
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.