Hello I have 650 commando rear differential.
By
silverbullet, in Joyner UTV SxS Forum
-
Similar Topics
-
By T-boss 410
I guess this is one for the general forum. Does anyone experience a slow turn over by the starter? I had a battery with a bad cell, and it was replaced. It wouldn't even turn over. Now it will start, but I have to hit the key a few times before it will spin over fast enough to start. The battery is a 330cca unit, so I would think that it would easily spin a single cylinder engine. This is for a Massimo T-boss 410. The engine is a 352cc, 25.5hp fuel injected unit.
Where should I start looking? It's a 2019 UTV, with only 14.6 hours on it. In my mind, I can only think that the connections somewhere are loose, or the starter is not up to snuff. Could tracing the wires for the starter system be difficult? Is there a way to test the starter?
Thanks much!
-
By Mark Popeye
Hi, Just purchased a 2010 Qlink Frontrunner 700. Using it to plow my yard (just moved back to NH). I knew it had starting issues but that was mostly around the starter relay (as shown, when I was looking at it). I rewired (and soldered) the 4 wires that go to relay, replaced the relay, starter and battery. It still starts extremely hard but runs great. I don't know what else to check. On another topic, which way do wheel hub nuts turn to loosen? TIA.
-
By [email protected]
won't start. I have checked out all electrical components, changed ignition, sensor shift indicator (wires partially broken off), starter relay, ignition coil, checked for broken wires, none were found. Fuses good
won't turnover, took out ECU, and EFI but still getting neutral on display. key bypassed by machine. Had it running once but nothing for the last 2 weeks. When running no reverse indicated on display.
-
By AshUoB
Hello everyone,
I am a mechanical engineering student who is trying to design a UTV to be used by maintenance workers around parks and university campuses. One of our unique selling points was that the rear cargo area would be modular so it can be swapped out for different "rear modules". For example, it could just be cargo hold but also a cage, refrigeration, more passenger seats or carrying woodchip etc.
What would be an easy way of detaching the different rear modules and swapping with a new one? A way of securing it to the frame but also allowing it to be removed with ease. From what I've seen, most UTV bodies are directly bolted to the frame.
Thank you for reading.
Ash
-