Quantcast
Jump to content

Anyone know how the turbo works on the trooper.


Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By great8redsfan
      Okay folks. I have a low power issue. Been like this for a few years. Place I work at bought 3 and all have lost most of the pulling power.  They gave them away after local shop worked on one for 3 months and it had great power for about 1 month and then crap. They replaced throttle body, fuel injector, spark plug and IAC motor. Seat belt switches have wires cut and left open so no seat belt warning light anymore. It revs to 6k rpm in neutral but when put in gear and take off in low it just doesn’t seem to want to go anymore. Running 93 octane fuel with Stabil.  Any ideas greatly appreciated. I dont have a scan tool but no codes on dash. If held to floor it pops a little and runs almost 5K rpm but if I let off pedal about an inch it smoothed out and revs up to 6k rpm. 
    • By Robert B
      Going down a 20 deg hill engine is holding UTV back. Then something releases like going into Neutral and makes a loud clacking noise. Have to use brake to slow UTV down. Then once level it shifts back into gear. Have done shift extension does not pop out of gear.
    • By goindeep
      Well now i could use a lil help... i have a trooper in my shop now that has wiring issues... this poor guy paid another shop $1000 to re wire the body control harness, and boy oh boy did they chop it up!!! I am Buillding a new harness from scratch... what i need is a diagram that tells me what each fuse and relay control on the Engine fuse/relay block.. any help is greatly appreciated!!
      Josh
      No Limitz
    • By lowgear52
      Does anyone out there have a rear differential for a trooper for sale?
    • By Hillbilly
      Hello everybody. I just tore a Yamaha apex snowmobile apart and I’m about ready to start fabbing up the mounting system for this thing. The Yamaha was in a stand alone setup. The gearbox was hard mounted to the chassis with the engine on four rubber mounts and that’s the way I’d like to build this too. 
      I ordered the secondary clutch from STM but it hasn’t arrived yet. The Yamaha secondary slid about 1/4” axially and I’m assuming that was to tolerate the fluctuation from the engine moving in the rubber mounts because of torque. I don’t believe the stm clutch has that slide action. 
      So my question is if I was to hard mount the rzr gearbox and leave the apex engine in its original mounts would the fluctuation from the primary under torque be bad enough to make the belts too far out of alignment ? 
      I’m not a fan of hard mounting the two together like Polaris does due to no ability to adjust the clutch alignment and the apex is sitting with fresh mounts installed in my garage as it sits. If I went with the rubber mounts that it already has I could be fabricating tomorrow. I’ve seen the kits available and I’m not paying that kind of money. Everything I need to fabricate this is sitting in my garage already. 
       
      Oh and the speed sensor. Anybody have to mess with this yet ? I have to assume the ratio from the apex gearbox and the Polaris gearbox are different. There’s no way I’d be that lucky  

       


       
       
×
×
  • Create New...