Viper 1100 cc And 800 cc C/V outer joints in now.
-
Popular Now
-
-
Similar Topics
-
By Jody Deville
I’m looking to best place to buy replacement axles for the rear in my buggy. Both axles are bad. Where is the best place to find them?
-
By Outlaw Redneck
Hello all. I have a 2005 Joyner sand spider 650 with the dreaded broken output shaft on the transmission. I got ahold of a 2007 joyner commando 650 for cheap that had a bad motor but a good transmission. I got it because everything i read said that the transmission would work but it seems that it will not. Due to the commando being 4x4 it has a selectable locker and a small ring gear using a "idler" gear to turn the ring gear which make the output spin the wrong direction. Is there any way that I can make this thing work? I really dont want a commando, I like the buggy but if the trans wont work then I can only put my motor in the commando. Any help would be appreciated. I have the ring gear from the original trans but the shaft is broken and the shaft from the commando wont fit the ring gear it doesn't appear.
-
By Recon Marine
Ran fine parked it in garage and 5 days later would not start or make any noise trying to start. Bought new battery, installed it and still nothing, no noise or anything.
Any idea? I can’t figure it out since when I parked it, it was running great.
Thanks
-
-
By GTech
I have a 2007 Joyner Commando 650, and cannot find a shift cable. Commando is a 4 speed, and the cable I need is the one to the right side of the shifter if you are sitting in the front seat. Cable is approximately 40", and has an eye on each end. I tried fitting a can-am shift cable, and the ends are just too long to mount and make work. Looking for a supplier so I can get the Joyner moving again with the correct shift cable.
Thank you,
Gary
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.