Strike and Sector 250 Exhaust finally done
-
Similar Topics
-
By Roadstar515
My drain plug is leaking at a slow pace but enough to be leaving oil on floor. Talk to dealer and I replaced o-ring and checked mating surfaces and all good. Still leaking but at a slower pace. Now dealer is calling Hisun to see what’s up. I’m thinking the recess in the drain plug was cut to deep and when installing o-ring it just doesn’t seem to leave enough rubber above the flush/crush portion of sealing surface. Maybe a defective drain plug, that would be my guess. Wondering if anyone has had this issue with there’s. Dealer said this is a first for him. Waiting on reply from dealer.
-
By RickinMT
I bought a new Axis 700 at Lowe's last Sunday, 7/24, and I didn't look through all my paperwork until the next day and there is no warranty info in the packet. I checked the Hisun site to see if you can register yourself and provide proof of purchase, etc., but they only have a form for Pre-Delivery & Customer Orientation Checklist which is to be filled out by the dealer and submitted to Hisun within ten days. I just called Lowe's and they're saying they automatically send it all in. How can I verify my warranty is registered with Hisun? I tried their phone number but of course right now it's after hours. I'll call again tomorrow but 10 days is pretty near.... I don't have any warranty claim yet but I just want to be sure it's registered.
Does anyone know a better way to check?
Thanks.
-
By techno10
Had this utv for a couple of months and bought it with this problem. Sometimes it will move thru the gears with no problems, but most of the time there’s a resistance to go from one gear to the next. What helps is to give it a little gas to get it to change gears. I’ve tried adjusting the turn buckle connected to the gear shift, but didn’t help. Anyone have any advice?
-
By RickinMT
2021 Hisun Axis 700
I just picked one up brand new at Lowe's last Sunday and I'm trying to carefully go through the break in time and I just noticed to day it's throwing fault codes.
P0113 IAT Circuit High Voltage or Open KsDGDM_IAT_ShortHigh 113 275
P0122 TPS Circuit Low Voltage or Open KsDGDM_TPS_ShortLow 122 290
P0201 Injector 1 Circuit Malfunction KsDGDM_INJ_CYL_A_Fault 201 513
P0351 Cylinder 1 Ignition Coil Malfunction KsDGDM_EST_A_Fault 351 849
P0650 MIL Circuit Malfunction KsDGDM_MIL_Circuit 650 1616
I noticed the codes while riding so it was already warmed up and working normally. Have no clue what all that means.....
Thanks.
-
-
-
Gallery Images
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.