Quantcast
Jump to content


Landmaster LM400

Josh
 Share

Recommended Posts

Josh Newbie

Josh

Posted
Posted

I have a land master  LM 400. Starts up just fine and idles fine but as soon as I run it for a little bit it seems to start sputtering so I pulled a choke out and it runs fine for a couple seconds and then I push the choke back in and it just shuts off. Any suggestions as to why? 

Travis Grand Master

Travis

Posted
Posted

Choking an engine provides a rich fuel mixture be lessening the amount of air entering the carburetor. So somewhere you have a fuel restriction, I would start by cleaning all fuel lines making sure the are clear of debris, if it has a fuel pump, be sure it works properly, and change the fuel filter.

If none of that works there's possibly a blocked jet in the carburetor that needs cleaned.

  • 5 weeks later...
vaughn Enthusiast

vaughn

Posted
Posted

Which engine? If it's the Robbin Subaru there is no fuel filter or fuel pump. It is basically a 9 hp lawn mower engine.  Sounds like the carb needs a good cleaning. 

Buggy.jpg

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Tim n Deb
      2015 Massimo stalled and wont start. oil, new plug, getting gas verified. cranks but does not start
      By Tim n Deb
      Riding out today it acted like it ran out of gas,  stalled and died and would not start.   Towed back to house,  New  plug added this past month,  plenty of oil, getting plenty of gas, battery cranks good.   Trys to kick in and starts but doesnt.   Two days prior while sitting at a idle it died.  Added gas and it started did my ranch chores with it.  But just now it stalled out cranks but will not start.   Tried to find if fault codes came up on the clock like manual says but not sure I am doing that right.  Any and all help apprecated.  Thank you
    • KWinTX
      Information on 2024 Hison 550x Stryker with a No start Issue
      By KWinTX
      I just bought a new 2024 Hison 550 Stryker 2 months ago. this is the second time I have had this issue.  It only has about 20 hours on it. The last time it happened we took it back to the dealer. it was a fuse.  Since we live three-hour time driving there and back. I would like to find another solution if possible.  I have tried all the fuses that seem to have anything to do with starting.  Currently checking the battery. The battery is new. it came with the unit. It is probably 6 months old.  the UTV has all power to everything electrical. lights turn signals and radio all work.  When trying the key to start . it is 100% dead. as in it doesn't even click.  There is a low whirring like the fuel pump is turning on though. The Unit was running and driving just fine.  we shut it down for the night. The next morning my wife found it in this condition.  Thanks for any Ideas or solutions???   Otherwise, it goes back to the dealer tomorrow. Just hope I didn't buy a lemon. Great little UTV when it does run.😅  anyone else ever have this Issue..? 
    • BigWave
      2019 hisun won't run
      By BigWave
      I turned off the key and then tried to start it a minute later and it would not start. I changed out the fuel filter and the injector. still nothing. if i have the injector pulled out and close to the hole the injector will spray fuel into the hole and it will run but the minute you put the injector in it will die. any idea's please
       
       
      Bigwave
       
    • Homeowner A
      Replacement Battery UTV 400
      By Homeowner A
      What's the best replacement battery option for a Coleman UTV 400?  
    • Mike Jenkins
      2013 hisun 700 will not run, cranks fine
      By Mike Jenkins
      I have a 2013 Hisun with a 686 Yamaha engine.
      I purchased it from an individual and it ran fine as long as the battery was full.
      I replaced the stator and now it will not start (run).  It cranks fine, has fuel pressure, but will not fire up.  I replaced the coil, no luck there.
      a technician told me that it was the wrong stator and wants a mint to replace it.
      the wires all plugged in when I installed the stator.
       

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...