Quantcast
Jump to content


2013 Kawasaki mule fuel injected

Red Good

By Red Good
in Kawasaki UTV SxS Forum

 Share

Recommended Posts

Red Good Rookie

Red Good

Posted
Posted

had no fuel pressure at the rail , checked all fuses ok , seems to have signal to the pump , checked the pump and replaced it . Still no go , where is the fuel pump relay on this particular machine? Thanks guys . .

Red Good Rookie

Red Good

Posted
  • Author
Posted

Is there a wiring diagram online here for this year or model ?  Different problem today , solenoid will no engage has power on hot leg with key on , has power signal when turned to start , only thing it can be is a failure to complete the circiut . What are there for safety features that would prevent starting . No wires to seat so not that . Park brake engaged , pedal brake engaged no different . box down , Any ideas . or a wiring diagram , please and thanks

 

Travis Grand Master

Travis

Posted
Posted
On 3/18/2020 at 2:15 PM, Travis said:

Model number?

Should be KAF-xxxxx

You'll need the above number to get a diagram, 

But, only parts diagrams are available, you'll need a workshop/service manual to get a detailed diagram with troubleshooting.

 

 

Red Good Rookie

Red Good

Posted
  • Author
Posted

Found online wiring diagram , only safety feature is neutral switch and it was bad ! this thing has hardly any hours on it . Spring tension in nuetral switch is so sad that you can shake it and the brass tip comes out another 16 th of an inch . damn . Thanks for the replies Travis

 

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Topics

    • Sammy
      2017 TW450 Kohler ECH440 runs out of fuel when running wide open.
      By Sammy
      Runs fine just putting around the yard. Get it out on the road and about a half miles it runs out of gas. Let it idle for a few minutes and it will run for another half mile and do it again. Replaced both fuel pumps and filter. Does anyone know if I can get rid of the factory fuel pump?
    • rdc
      Joyner 1100 oil pressure problem.
      By rdc
      I have a 2007 Joyner 1100 sand viper and  before it even get's to where the thermostat opens up the oil pressure get's so low I have to shut it down. What could fix this ? I thought about adding an oil cooler with fan, thicker oil, or removing the thermostat. Any advice?
    • Hoppy one
      Bennche 500, replaced stator no fire
      By Hoppy one
      I replaced the stator on our Bennche 500 because it was not charging. It ran as long as you kept the battery charged. I replaced the stator now it’s not firing. The only problem I found was a wire in the new stator for the crank position sensor was in the wrong place in the plug. I switched it around but still no fire. Putting a meter on those wires and cranking the motor showed no voltage from the crank position sensor. Something I did or a bad “new “ part? Thanks for any ideas.
    • Jeff freeman
      Utv wont start and broken fuel injection wire
      By Jeff freeman
      I have a Coleman 550.  Was having problems to start with where it would start and then shut off after a couple tries. It would take off and be good. It then got to a point where it would not start at all. I replaced the fuel injection twice the second time I replaced it I noticed a mouse or something had chewed one of the wires that connect the electrical to the fuel injector. . So two-part question first does anybody have a part number for that wire harness?  Second, any other ideas after I fix the wire harness permanently on what could keep it from starting I have gas flow up to the fuel injector.


    • Garjess
      RTV 1140 Starter Relay
      By Garjess
      My rtv 1140 won't turn over.  I've jumped the neutral switch, and the brake switch, and checked the ignition switch. I'm not getting any power to the trigger wire on the starter solenoid.  It starts fine with the key on and putting power to the trigger wire on the solonoid.
      Does a 2010 RTV 1140 cpx have a starter relay? 
      Does anyone have a wiring diagram?

UTV FORUMS

MORE SECTIONS

FOLLOW US ON

GET IN TOUCH

  • Automotive Webmaster
×
×
  • Create New...