Quantcast
Jump to content


Recommended Posts

Posted

Hello everyone.  I picked up a 2012 hisun strike 800 UTV.  Previous owner said that it overheated.  They were trying to drive it back to their vehicle and said it just stopped running.  He said he thought it was a blown head gasket.  They replaced fuel pump and looks like a new starter solenoid relay.   It does not have any antifreeze in the oil so don’t think its head gasket (I ordered new ones anyway). It turns over but not with a lot of juice.  (Kind of like an almost dead battery). I put in a new battery but still does the same thing.  Any thoughts?

  • Alex changed the title to 2012 Hisun Strike 800 UTV No Start
  • 3 weeks later...
Posted

I would do a compression check just to ease my mind.  The spark plug(s) can tell you about the conditon of the cylinders, too.  How does the engine turn over with the starter and with the plugs removed?  You could still have a blown head gasket.  There are three combinations:  Cylinder to coolant jacket, cylinder to oil passages, oil passage to coolant jacket.  Overheating can cause the head to warp just enough to blow the head gasket or distort the cylinder walls or cause the rings to seize up.  A weal starter can be the issue with slow turning of the engine (experienced that with my riding mower).

  • 7 months later...
Posted

I just bought a coleman 800 hisun motor. I am having a problem with over heat light comes on but my radiator is still cold so fans don't turn on. Is there another heat relay somewhere on engine. It is getting warm but not coolant to radiator? water in radiator is still cold? Does it need new water pump or do you think it has a bubble lock somewhere?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Topics

    • By AaronD1982
      Next problem with charging system to tackle, any help would be appreciated.
      New starter solenoid....check
      New Voltage Regulator...check.
      Dynamic test to Stator.....bang...pulling like 2 Volts AC
      Problem: Without pulling the part out and stranding the vehicle at the shop forever.... I am trying to find the correct stator or at least one that might not be exact for the Massimo Buck 400S, but fit and connect and do the job if that makes sense.... if anyone has any ideas, please shoot them my way.
    • By rdc
      I posted this before , but I had the year wrong. The part I need is for a 2014, I don't know what all years will work, but I need the 2 bearing style with the spacer in the middle. It looks like this pic. If anyone has one I'll buy it rite away. my email is [email protected]. Thanks, RC

    • By Fmaxiron
      I just purchased a 2023 Honda Pioneer a couple of weeks ago and had the hard roof and a front Honda Pioneer windshield installed at the shop before taking ownership. As things are drying up here in NC, the grass and dust are beginning to fly right through the back of the cab while driving. I was wondering if anyone has any good recommendations on rear windshields, dust panels, or mesh screens to help stop this?
      Thanks a lot!
    • By rdc
      Hope I posted this in the right place. Looking for the left side shaft carrier where the rear bearings go for an 1100cc sand viper, I understand an 800 cc carrier will also work. I need the old style two bearing with the spacer in the middle, the new style with just the one wide bearing wont work. If anybody has one I'll buy it right away. my email is [email protected]
    • By Burk
      I have a 2021 Axis(Hisun) 700 from Lowes. Will not start. Checked starter, solenoid, spark plug and fuel pump. Everything seems to be fine. The motor turns over and will try to start but just will not. Battery is also good. Frustrated!
×
×
  • Create New...